Advertisement
12/9/2019
Reliability
Thermal Rating
Regulatory Compliance
Electromagnetic Emission and
Immunity
Safety
Stacking restrictions
Regulatory Information
The following information is for FCC compliance of Class B devices:
The equipment described in this manual generates and may radiate radio-frequency energy. If it is not
installed in accordance with Cisco's installation instructions, it may cause interference with radio and
television reception. This equipment has been tested and found to comply with the limits for a Class B digital
device in accordance with the speci cations in part 15 of the FCC rules. These speci cations are designed
to provide reasonable protection against such interference in a residential installation. However, there is no
guarantee that interference will not occur in a particular installation.
Modifying the equipment without Cisco's written authorization may result in the equipment no longer
complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any interference to radio
or television communications at your own expense.
You can determine whether your equipment is causing interference by turning it o . If the interference stops,
it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment causes
interference to radio or television reception, try to correct the interference by using one or more of the
following measures:
Turn the television or radio antenna until the interference stops.
Move the equipment to one side or the other of the television or radio.
https://www.cisco.com/c/en/us/td/docs/wireless/access_point/power/guide/air_pwrinj6.html
Cisco Aironet Power Injector AIR-PWRINJ6= Installation Guide - Cisco
Operating Humidity:
Maximum 90%, Non-condensing
Storage Temperature:
-4ºF to 158ºF (-20ºC to 70ºC)
MTBF: 100,000 hrs @ 25ºC
20 BTU/Hr @ 240 V AC
IEEE 802.3 at (PoE), China RoHS Compliant, WEEE Compliant, CE
Compliant
FCC Part 15, Class B
EN 55022 Class B (Emissions)
EN 55024 (Immunity)
VCCI
UL 60950-1
IEC/EN 60950-1
Do not stack. Do not bundle the power injector and AC power
cable.
6/7
Advertisement
