Digital Home Systems HiWatch Setup

1. Set cameras positioning, this can be done by removing the cover from the camera using a screw driver and then
adjusting the cameras angle to suit your needs. (Ensure the cover is back in place before beginning step 2)
2. Install the SADPTool software that comes with the Camera on the disk onto your computer.
3. Connect your camera to a power supply and your router via an Ethernet cable, the camera also supports PoE
(Power over Ethernet).
4. Load up the SADPTool software and select your camera from the list, you will need to activate the camera and you
will be prompted to create a password for the device.
5. Once set-up has been complete you will be able to access your camera via the IP that has been assigned to the
device, if you selected DHCP upon set-up you will need to access your router via a web browser and locate the
section of your router that shows connected devices to find the IP.
1. Open up your Vera UI and selected devices and go to add devices, enter 'IP Cam' into the search bar then scroll
down and select Generic IP Camera wizard.
2. Skip thought steps 1-3 and select Manually install the camera.
© 2017 Digital Home Systems Pty Ltd. All rights to this document are reserved.

HiWatch IP Camera Set-up

VERA Integration (UI7)