Advertisement
Disconnect the power source cable before any operation of cleaning of
maintenance and accessories assembly.
Never modify the appliance in anyway.
Make sure that the sharpener is completely dry and free of grease.
Place the appliance on a flat surface. Plug the appliance into a mains socket.
Turn the sharpener selector in order to select the type of tool to be sharpened.
Move the selector until the reference mark (white dot with the symbol of the tool) is
positioned at the top of the appliance.
Number 4
For Number 1 : Use the two slots in turn so that both surfaces of the blade will be
For Number 4 : There are two apertures on the front, for different sizes of
Warning: The symbol
Do not select this symbol for sharpening a tool.
Holding the appliance with one hand, press the Start/Stop button.
The Sharpener starts turning.
Note : The appliance Runs until you push on the button. It's stops when you release the
button.
Holding the tool to be sharpened in the other hand, position it in the appropriate slot.
Move the blade from the base towards the point, using a constant pressure.
NOTES :
The sharpening process must not be stopped suddenly, and the pressure applied
on the tool must not change, otherwise, this could cause notches on the blade.
If necessary, incline the blade slightly in the slot in order to adjust the position of
the blade with respect to the whetstone.
The selector has a slight play, allowing you to adjust the blade on the
whetstone.
Unplug the appliance after each use.
Sharpened.
screwdrivers.
is reserved for removing the sharpener selector.
7
Advertisement
