easymaxx TS-21548 Operating Instructions Manual page 26

EN
1. Plug the device into a properly installed, easily accessible
wall socket.
2. To switch on the device, set the On / Off switch (2) to po-
sition I. The "fi replace look" lighting (5) and fan heater (4)
come on. In the display (6) "88" lights up briefl y and then the
current temperature appears. The heating process starts.
3. Press the + button (8) to switch the "fi replace look" lighting
on or off .
4. Press the Menu button (9) to switch to setting mode:
– Press once:
– Press twice:
– Press three times:
5. Use the + and – buttons (7) to set the desired temperature
(15 – 35 °C), speed (LL / HH) and timer (00 – 12 H). When
the display stops fl ashing and changes to the current tem-
perature, the settings are saved.
To turn off the timer, set it to "00".
Please note: The device automatically stops heating as
soon as the set temperature is reached. If it cools down
again, the device will heat up again as long as it is switched
on.
6. To switch off the device, set the On / Off switch to position 0.
The display and, if switched on, the "fi replace look" lighting
go out and the fan heater switches off .
The device can be switched to stand-by mode by
pressing the Standby button (10) on the remote con-
trol. The display and, if switched on, the "fi replace
look" lighting go out and the fan heater switches off .
26
Setting the temperature
Setting the speed
Setting the timer