Download Print this page

EasyPro DDK50 Instructions For Operation, Safety, Warranty

Bubble tubing deicer kit

Advertisement

Quick Links

DDK50
Instructions for Operation • Safety • Warranty
Thank you for your purchase of an EasyPro bubble tubing deicer kit. EasyPro deicer kits
are designed to be an energy efficient way to keep your dock, boat lift, piers, etc. free
from ice formations. These kits are also great for shallow water aeration applications.
Bubble tubing lays on bottom and pushes warmer water from the bottom up to the
surface preventing ice from forming.
Self weighted bubble tubing conforms to any shape needed.
Kits include compressor, 15' of
tubing, fittings and clamps.
Required cabinet or enclosure sold separately.
Safety and Electrical
Warning - Risk of electrical shock. For your protection always unplug the unit from
its power source before installing or servicing.
Warning - This compressor is solely intended to pump air. It is not for use with oil,
solvents or any petroleum products (gasoline, diesel, etc.).
Always use a properly grounded AC outlet. Keep plug end from moisture and do not
attempt to plug in a wet plug.
Provide a "drip loop" for the line cord. This is a loop in the cord below the level of
the receptacle or plug that prevents water from traveling along the cord into the
receptacle.
Be sure that a Ground Fault Circuit Interrupter (GFCI) is installed in the branch circuit
supplying the equipment.
Unit should be installed horizontally and above the height of water surface.
Do not submerse or flood compressor. Do not place compressor where it could fall
into water.
Do not operate if power cord is damaged.
Use extreme caution when operation in winter. Danger due to thin ice can cause
drowning. Unseen currents can cause thin ice in areas ling distances away from
diffuser operation. Provide adequate warning for others when operating this system.
Always wear a Coast Guard approved life vest when working in or near water and
follow all safety guidelines.
Note: EasyPro Pond Products is not responsible for losses, injury or death as a result of
failure to follow these safety warnings, misuse or abuse of equipment.
DDK50 • DDK100E
Bubble Tubing Deicer Kit
/
" weighted feeder tubing, 50' or 100' bubble
5
8
DDK100E

Advertisement

loading

Summary of Contents for EasyPro DDK50

  • Page 1 Always wear a Coast Guard approved life vest when working in or near water and follow all safety guidelines. Note: EasyPro Pond Products is not responsible for losses, injury or death as a result of failure to follow these safety warnings, misuse or abuse of equipment.
  • Page 2 Bubble Tubing Deicer Kit Components Compressor Part # Compressor Feeder Tubing Bubble Tubing Repair Kits DDK50 SRC25 15' Weighted SRC25K DDK100E SRC50 15' Weighted 100' SRC50K Installation Configurations This kit can be assembled in three possible configurations using the fittings below depending on your pond, dock and deicing needs.
  • Page 3 General Instructions DDK50 Compressors require protection from elements. DO NOT place your compressor in low spots or any place water may puddle. Flooded compressors are not covered under warranty. Select preferred installation style (see DDK100E previous page) and determine position of compressor.
  • Page 4 Inspect wearable components inside compressor. Replace as necessary. Limited Warranty: • Compressors in DDK50/DDK100E kits have a two year limited warranty (see owners manual for complete warranty information) • Quick sink tubing and bubble tubing have five year limited warranty Other items included in this kit that are not listed above are considered wearable items and are not covered under this warranty.

This manual is also suitable for:

Ddk100e