Hide thumbs Also See for WeatherBoss:

Advertisement

Quick Links

WeatherBoss
Installation Manual
BARTLETT
Instrument Co.
1032 Ave. H
Fort Madison, IA 52627
319-372-8366
www.bartinst.com
10/20/20
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WeatherBoss and is the answer not in the manual?

Questions and answers

Summary of Contents for Bartlett WeatherBoss

  • Page 1 WeatherBoss Installation Manual BARTLETT Instrument Co. 1032 Ave. H Fort Madison, IA 52627 319-372-8366 www.bartinst.com 10/20/20...
  • Page 2: Installation Overview

    The WeatherBoss includes wind, rain, temperature, humidity and light readings. The WeatherBoss is both a wind and rain alarm and can act as a remote sensor module. As a wind and rain alarm, it will activate an output when the wind speed exceeds a programmed wind speed set point or the rain sensor detects a programmed level of moisture on the sensor surface.
  • Page 3 THE WEATHERBOSS IS A LOW VOLTAGE DEVICE. LIMITED TO 24V AC CONTROL VOLTAGES. CAUTION: The WeatherBoss is designed to be reliable but as with all equipment, failures do occur. Therefore, in situations where loss could result from the failure of the WeatherBoss, separate backup thermostat or alarm systems should be provided.
  • Page 4: Placement And Mounting

    (up to 3 days) before closing control box to avoid corrosion damage. To mount the WeatherBoss, remove the front cover and unplug ribbon cable from the relay board. Insert the 4 self-drilling screws provided with the WeatherBoss through the 4 screw-hole knockouts and fasten the box to the wall.
  • Page 5: Temperature Sensor

    WeatherBoss Outputs The WeatherBoss has three alarm outputs – wind alarm, rain alarm, and wind or rain alarm. The wind and rain outputs activate separately based on individual sensors. The “wind or rain” output activates when either sensor exceeds its set point.
  • Page 6: Connection Locations

    Connection Locations WIND OR RAIN ALARM THERMISTOR UNUSED RAIN SENSOR UNUSED UNUSED Wind Direction UNUSED HUMIDITY PROBE Radio Module 9 10 11 12 TERMINAL DESCRIPTION TERMINAL DESCRIPTION TERMINAL DESCRIPTION 24VAC Power (For Controller and Rain Sensor) 24VAC COM (For Controller and Rain Sensor) WIND ALARM THERMISTOR...
  • Page 7 Communications PINK ORANGE To Relay Board TERMINAL DESCRIPTION Pink Wind Speed Connection Orange Wind Speed Connection Red/Green Light (PAR) Sensor Connection Red/Yellow Light (PAR) Sensor Connection 10/20/20...
  • Page 8 10/20/20...
  • Page 9 10/20/20...

Table of Contents