Axis M30 Series User Manual page 19

AXIS M30 Network Camera Series
Additional settings
2. Connect the power wire to pin 2 (12V DC output).
3. Connect the I/O wire to pin 3 (I/O input).
Connect the wires to the PIR detector's I/O connector
1. Connect the other end of the ground wire to pin 1 (GND/-).
2. Connect the other end of the power wire to pin 2 (DC input/+).
3. Connect the other end of the I/O wire to pin 3 (I/O output).
Configure the I/O port in the camera's webpage
1. Go to Settings > System > I/O ports.
2. Give the input module a descriptive name.
3. To make the PIR detector send a signal to the camera when it senses motion, select Closed circuit in the drop-down list.
To trigger the camera to start recording when it receives a signal from the PIR detector, you need to create a rule in the camera's
webpage.
Detect tampering with input signal
This example explains how to trigger an alarm when the input signal has been cut or short-circuited. For more information about the
I/O connector, see page 27.
1. Go to Settings > System > I/O Ports and turn on Supervised I/O.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, select Digital input and then select a port.
4. In the list of actions, select Send notification to email and then select a recipient from the list. Go to Recipients
to create a new recipient.
To watch this video, go to the web version of this document.
www.axis.com/products/online-manual/34428#t10110432
How to send an email notification when someone tampers with the input signal
19