Before operating the unit, please read this manual thoroughly and retain it for future reference. Copyright Copyright 2015-2016 Bolin Technology all rights reserved. No part of this manual may be copied, reproduced, translated, or distributed in any form or by any means without prior consent in writing from our company.
Page 4
Maintenance Precautions: • If there is dust on the front glass surface, remove the dust gently using an oil-free brush or a rubber dust blowing ball. • If there is grease or a dust stain on the front glass surface, clean the glass surface gently from the center outward using anti-static gloves or an oil-free cloth.
Overview Camera Version HDBaseT Version: HV:V.D.0000cdjk.14.001.01.A02 Model Numbers This user guide is suitable for the following models: • VCC-4K-BR Features • HDBaseT SingleWire Technology • Uses One Cat5e/6 Ethernet cable (up to 100meters) to deliver camera power, up to 4K resolution video output, RJ45 to RS232/RS422/RS485 control and Audio.
HDBaseT Adapter 1. LAN Port(RJ45) Connect network switch or router to this port for Ethernet. (Not an IP encoder) 2. IR Remote Controller Indicator These are sensors to receive commands from infrared remote controller, distance up to 10 meters. 3. RS-422 Control Port Use RJ45 to RS-422 extension adapter cable to remotely control PTZ camera.
System Configuration Connection When the camera is connected to a computer and joystick keyboard with a VISCA cable (cross type, RS-232), you can operate the camera with the computer and the joystick keyboard. When the camera is connected to a joystick keyboard a control cable (cross type, RS-422/485), you can operate the camera’s pan, tilt, zoom with the joystick keyboard.
Camera Control Methods and System Configurations This unit has multiple ways of controlling the camera and various system configuration capabilities using optional products. This section describes ways of controlling and typical system examples with the required components and usage of each system. 1.
Page 10
RS232 and RS422/RS485 Control Connection There are two ways to make the RS232 and RS422/RS485 control cable connection: Use Cat 6 network cable to make the RJ45 connectors to connect to the camera. Follow the pinout bellow to make the RJ45 connectors. Use extension cables included to connect the RS232/RS422 control cable: RJ45 to RS232 extension adapter cable.
Page 11
Note For control details, refer to Operating Instructions of control keyboard/station software. • You need to match the Baud Rate between the camera and the joystick controller. • You cannot use the RS-232 connections when using the RS422/485 connection. Operating Multiple Cameras Using RS-422/485 •...
Need help?
Do you have a question about the VCC-BR-M-11132017 and is the answer not in the manual?
Questions and answers