Advertisement
To read before assembly to take full advantage of your new shed
You just received your shed and we wish that this product will bring you entire satisfaction.
This shed is made out of northern spruce wood. Wood cannot be industrially created, it's a natural organic material,
unique, which inspires its charm thanks to its imperfections. Knots and cracks are not defects but particularities of this
noble material. Wood continue to evolve and dye over time. It is likely to swell slightly during winter periods because
of humidity and retract during dry periods. These dimensional variations are quite normal and predictable and do not
affect the strength, stability and functionality of the product.
Assembly preamble:
-
In order to guarantee the durability of your shed, it must be mounted on a flat and level concrete slab, with
appropriate dimensions (shed ground dimension +2cm, not exceeding shed over all dimension) in order to
avoid any water retention. It must be isolated from the ground to prevent moisture rise and built according
to rules of execution (with waterproof membrane for example). The position of the shed must be studied
to not expose it to the prevailing wind.
-
Before the assembly, leave your package protected from bad weather.
-
Before you start the assembly, make a complete inventory of the parts.
-
The shed is in natural dry wood that is free from any protective treatment. Before the assembly, wood
components must be treated one by one on all sides with an insecticide and fungicide protection. Make
sure to respect the recommendations of the applied product (application, drying, ...) The drying must
imperatively be done flat to avoid any deformation of the parts.
-
Once the shed is mounted, apply two layers of water-repellent and UV-resistant microporous stain outside
and inside the shed. Make sure to respect the recommendations of the applied product (application,
drying,...)
-
Surface to be treated and stain : 65m²
This product must be mounted by at least two persons. The estimated assembly time is one day.
Roof specifications:
-
The shed you received has a metallic roof, modern, durable and aesthetic. The tiles are steel treated. They
should be handled with care to avoid any damage on treated surface. If it is necessary to step on or lean
on it during assembly, use soft-soled shoes and place your feet in the deep of the waves. Before doing this,
check that all the screws are screwed. To ensure security, you should lean on beams level.
-
The metal chips from drilled holes made on tiles must be removed with a soft brush, because while rusting,
they can damage the treatment of the tiles.
-
The roof has been specially designed for this shed and requires no cutting or special implementation.
-
The recommended tool for screwing the roof is the drill-screw-gun. The recommended rotation speed is
1800 rpm max, tightening 3Nm with 8mm hex screw head.
4
Advertisement
