Table of Contents
Advertisement
Quick Links
SOLAR
WATERS EVERY
MORE SUN =
USE WITH A
POWERED
3 HRS
MORE WATER
WATER TANK
OR TAP
Instructions: Irrigatia Solar Automatic C60, C120 and C180 Watering Kits
Instructions: Kits d'arrosage automatiques Irrigatia Solar C60, C120 et C180
Anleitung: Irrigatia Solar Automatische C60, C120 und C180 Bewässerung Kits
Instrucciones: Irrigatia Solar Automatic C60, C120 y C180 Kits de Riego
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Irrigatia Solar Automatic C60
Summary of Contents for Irrigatia Solar Automatic C60
- Page 1 Instructions: Irrigatia Solar Automatic C60, C120 and C180 Watering Kits Instructions: Kits d’arrosage automatiques Irrigatia Solar C60, C120 et C180 Anleitung: Irrigatia Solar Automatische C60, C120 und C180 Bewässerung Kits Instrucciones: Irrigatia Solar Automatic C60, C120 y C180 Kits de Riego...
- Page 2 Contents Tank series controller Water level sensor Solar Panel with 5m 1 x inline filter + with main pump and lead (model shown is 2 x 13mm adaptors secondary feed pump the C120) 1 x foot strainer + 1 x 25m roll of 1 x 2.5m 3.5mm tube 1 x 4mm punch 2 x 13mm adaptors &...
- Page 3 User Instructions for Irrigatia Tank Series For video instructions: irrigatia.com/how-it-works/setuptank-series Figure 1 1. Tank 5. Inline filter 2. Foot strainer 6. Solar panel 3. Isolation valve 7. Regulating valve 4. Pump 8. Anti-siphon device...
- Page 4 Postioning Using the fixing holes indicated by the green arrows, mount the controller close to the water source and low down so that the pump inlet (Standard or submersible) is below the water line in the tank. The controller case is weather resistant but can be mounted inside if desired.
- Page 5 Foot Strainer Standard Pump Top entry Vertical Resting on tank bottom (see fig 4) Figure 4 Water Level Sensor The water level sensor should be secured so that the is a nuisance it can be silenced by unplugging it from the higher probe is at least 3cm higher than the water inlet.
- Page 6 15m of small bore tube.) Cut and join the pipe using nipple to connect with the distribution pipe. the tees to make a network which reaches all of the plants. Remember the rules for even watering apply especially where there are more than 12 drippers per outlet, see: irrigatia.com/how-it-works/principles-of-good-installation...
- Page 7 Starting up Battery case Open regulating and isolation valves (3&7 in drawings) fully – handle in line with tube. Ensure there is water flow to the pump. Circuit board Open the case. Main pump • Unplug the feed pump from the circuit board – marked as pump 2 on the board.
- Page 8 Detailed instructions can be found at: irrigatia.com/how-it-works/setuptank-series SOL-C60 SOL-C120 SOL-C180 60x 120x 120x 120x 240x 50x 120m 180x 180x 360x 75x 180m For further information on this or any of the other products in our range, please visit: www.irrigatia.com...
Need help?
Do you have a question about the Solar Automatic C60 and is the answer not in the manual?
Questions and answers