Advertisement
Rev. 12/5/2017
Signal Words:
This manual uses SIGNAL WORDS to indicate the likelihood of personal injuries, as well as the probable
seriousness of those injuries, if the product is misused in the ways described. Other signal words call attention to
uses of the product likely cause property damage.
The signal words used appear below along with the meaning of each word:
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or
SERIOUS INJURY.
situations.
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or
SERIOUS INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in MINOR or
MODERATE injury.
Identifies practices likely to result in product/property damage, such as operation that
might damage the product.
Each person who assembles, installs, uses, or maintains this product should read the entire manual and fully
understand the directions in advance. If after reading the manual you do not understand an instruction, ask
your supervisor or employer for clarification, because failure to adhere to the directions in this manual
might result in serious personal injury.
Safety Guidelines:
Vestil strives to identify all foreseeable hazards associated with the use of its products. However, no manual can
address every possible risk. The most effective means for avoiding injury is to read all of the instructions prior to
putting the steps into service and to apply sound judgment whenever using them.
Improper or careless use could result in serious personal injuries.
Read and understand the entire manual before assembling, using or servicing the product. Read the manual to
refresh your understanding of proper use and maintenance procedures.
DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil. Unapproved
modifications automatically void the Limited Warranty on p. 6 and might make the steps unsafe to use.
DO NOT exceed the capacity (see Label 287 in "Labeling diagram" on page 5). The net weight applied to the stand at
any time must not exceed 500 pounds.
DO NOT use the step stand unless it is level. Adjust the legs to level the steps. (See "Height adjustment" on p. 5).
DO NOT use the steps on sloping or uneven ground. Only use the steps on level, even ground.
DO NOT reach or lean far beyond the perimeter of the steps. Reaching or leaning could cause the steps to tip over.
Inspect the product as described in "Inspections" (below). DO NOT use the steps unless they are in normal condition.
Complete all necessary repairs and replacements before returning the product to service. DO NOT use the product
until it is entirely restored to normal condition.
DO NOT use this device UNLESS all product labels (see "Labeling Diagram" on p. 5) are readable and undamaged.
Proper use, maintenance, and storage are essential for this product to function properly.
o Apply touchup paint to all areas where the original finish is damaged. Use a steel bristle brush or steel wool to
remove rust.
o Keep the product clean & dry.
o Periodically oil the threads of each leg.
Inspections:
Before putting the step stand into service, inspect it closely. Make a written record that describes the
appearance of the steps, the finish (paint/powder coat), the legs, and the rubber cap on the bottom of
each leg. This written record establishes "normal condition". Inspect the unit before each use.
Compare the inspection results to the written record to determine if the stand is in normal condition.
Complete all repairs and replacements necessary to restore the unit to normal condition BEFORE
using it again.
To order replacement leg caps, contact our service department at refer to part number 14-037-004.
Handrails and mounting hardware is also available.
Copyright 2017 Vestil Manufacturing Corp.
Use of this signal word is limited to the most extreme
ASP, MANUAL
Page 2 of 6
Advertisement
