Advertisement
4. ASSEMBLY
4.1.
Select a suitable hard and level surface upon which to use the ramp.
4.2.
Lay out the required blocks and interlink them as shown in fig.5. Ensure full engagement of interlocks.
4.3.
Set each leg of ramp to line up with the other in length and to run parallel in width.
4.4.
Set width between ramps to suit vehicle tyre track such that ramps are centered to tyre centre lines. Failure to do so may result in the
vehicle dropping off the ramps.
fig.2
5. OPERATION
NOTE: Ensure that you have read and understood the safety instructions for this item (section 1) before use.
5.1.
With ramps set to the correct width for the vehicle being loaded and alignment of them being parallel, drive the vehicle slowly and
cautiously onto or down from the ramps, preferably being guided by a second person.
fig.5
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
fig.3
Parts support is available for this product. Please log on to
www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500
01284 703534
Original Language Version
fig.4
sales@sealey.co.uk
www.sealey.co.uk
PRK01
Issue 1 10/01/19
Advertisement
