Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Flo FLO Home G5
Summary of Contents for Flo FLO Home G5
- Page 1 Home G5 Model Installation guide...
-
Page 3: Table Of Contents
Table of Contents Safety Instructions Before You Install Box Contents Installing the Station Setting the Current Limit Light Indicator Compliance Limited Warranty Assistance Charging Station Serial Number Casing: 100% aluminum NEMA 4X Certified, designed for outdoor or indoor installation Voltage: 208 - 240 V @ 60 Hz Output Current: 30 A Maximum Output Power: 7.2 kW @ 240 V or 6.2 kW @ 208 V Charging Connector: SAE J1772 designed to withstand over... -
Page 4: Safety Instructions
This charging station is to be used to charge vehicles that do not require a ventilated environment during charging. Always disconnect the power supply of the charging station before servicing. September 2018 | flo.com | Installation guide | FLO Home G5... -
Page 5: Before You Install
Maximum output power: 7.2 kW @ 240 V or 6.2 kW @ 208 V Figure 1 Single-Phase 120/240 VAC Charging Station Ground Ground Figure 2 3-Phase 120/208 VAC Charging Station Ground FLO Home G5 | Installation guide | flo.com | September 2018... -
Page 6: Box Contents
Recommended height to facilitate handling of the connector, as well as preventing the cable from touching the ground. 7,6 in 6,9 in 19,3 cm 17,5 cm 17 in 43,2 cm 60 in 152,4 cm Floor September 2018 | flo.com | Installation guide | FLO Home G5... -
Page 7: Installing The Station
The power supply cable can be inserted from the rear (a) or from under (b) the station: - 3/4’’ knockout (a) and (b) - Remove a single cap - Strain relief not included FLO Home G5 | Installation guide | flo.com | September 2018... - Page 8 Secure the rear housing of the station to the mount- ing plate. Screw the lower screw to secure the mounting. September 2018 | flo.com | Installation guide | FLO Home G5...
- Page 9 B) Tighten the 2 front screws with a nominal torque of 55 lbs-in. Detail A About 30° Switch on the electrical circuit breaker. Your new station can now charge your vehicle! FLO Home G5 | Installation guide | flo.com | September 2018...
-
Page 10: Setting The Current Limit
Setting the Current Limit By default, the FLO Home G5 is set to maximum power (factory). If your home’s electrical infrastructure does not allow the charging station at maximum power (or pre- venting any potential current overload), it can be reduced using the Current Limiter Switch. - Page 11 Circuit Breaker (A) Switch Position Power (A) * in Breaker Panel Not Used Not Used Not Used Not Used Put back the front housing. Switch “ON“ the charging station. FLO Home G5 | Installation guide | flo.com | September 2018...
-
Page 12: Light Indicator
(switch off the station and then restart it and if the problem persists, contact our technical support) 7+ times Internal error (switch off the station and then restart it and if the problem persists, contact our technical support) September 2018 | flo.com | Installation guide | FLO Home G5... -
Page 13: Compliance
- CSA C22.2 No. 0.8-12 Safety functions incorporating electronic technology. - UL1998 Standard for software in programmable components. - UL991 Standard for Tests for Safety-Related Controls Employing Solid-State Devices. - NEC 2014 section 625. FLO Home G5 | Installation guide | flo.com | September 2018... -
Page 14: Limited Warranty
Product. 4.Limited Remedies. FLO’s obligations under this Limited Product Warranty are limited to repairing or replacing or reimbursing the purchase price, at FLO’s sole discretion, any Product which is found to be defective by FLO after proper inspection. All replacement or repaired Products are warranted only for the remainder of the original Warranty Period, prolonged only by the period during which the Product was repaired or replaced. -
Page 15: Assistance
A customer experience or technical support representative can assist you! Customer and Technical Support For any questions regarding charging station installation, configuration or any technical problem. 1-855-543-8356 You can also contact us at: service@flo.com FLO Home G5 | Installation guide | flo.com | September 2018... -
Page 16: Charging Station Serial Number
Volt: 208 / 240 VAC 60Hz Courant max: 30A Amp: 30A max Boîtier / Enclosure: Type 4x Date Code: 201611 Operating Temp: -40 C to 50 FLO Home charging station bottom view September 2018 | flo.com | Installation guide | FLO Home G5... - Page 17 2 Hold your smart phone at a 20 angle under the charging station. 3 Line up the phone screen with the serial number sticker 4 When you see the sticker take the picture. FLO Home G5 | Installation guide | flo.com | September 2018...
- Page 18 THIS PAGE IS INTENTIONALLY LEFT BLANK...