Advertisement
About this document
This document concerns the EB006V9 E-blocks
PICmicro multiprogrammer board (version 9).
1. Trademarks and copyright
PIC and PICmicro are registered trademarks of Arizona
Microchip Inc.
E-blocks is a trademark of Matrix
Technology Solutions Ltd.
2. Disclaimer
The information provided within this document is
correct at the time of going to press. Matrix TSL reserves
the right to change specifications from TSL to time.
3. Testing this product
It is advisable to test the product upon receiving it to
ensure it works correctly. Matrix provides test procedures
The EB006 V9 PICmicro microcontroller programmer
connects to your PC via USB to provide you with a low
cost and flexible PICmicro microcontroller programmer.
This board can be used with conventional microcontroller
programs that generate hex code for the PIC family:
MPLAB, C compilers, BASIC compilers etc. The EB006
V9 has many features that are optimised for use with
Flowcode version 6 including Ghost technology.
The board will program most 8, 14, 18, 20, 28 and 40 pin
flash PICmicro microcontroller devices using the free
'mLoader' programming software provided. mLoader
can be downloaded from the Matrix web site.
The board also provides 'clean' access to all Input/Output
lines on the relevant PICmicro microcontroller device.
These are presented on 9 way D-type connectors: 8 bits
and earth. A range of additional E-blocks boards can
plug into these D-type connectors to provide a rapid
prototyping system for learning and development.
More information on Ghost technology can be found on
our website at www.matrixtsl.com/ghost.
3
for all E-blocks, which can be found in the Support
section of the website.
4. Product support
If you require support for this product then please
visit the Matrix website, which contains many learning
resources for the E-blocks series. On our website you will
find:
•
How to get started with E-blocks - if you are new to
E-blocks and wish to learn how to use them from the
beginning there are resources available to help.
•
Relevant software and hardware that allow you to use
your E-blocks product better.
•
Example files and programs.
•
Ways to get technical support for your product, either
via the forums or by contacting us directly.
General information
1. Features
•
E-blocks compatible
•
Low cost
•
Used as a programmer and as a development board
•
Programs a wide range of PICmicro MCU devices
•
Full suite of programming software available
•
Ghost technology included
•
Removable crystal oscillator source
•
5 I/O ports
•
In-Circuit Debugging via PICkit2 connector
•
In-Circuit Debug with Flowcode 6
•
In-Circuit Test with Flowcode 6
•
Charge pump capability to allow high voltage
programming from USB supply
•
2mm power connector sockets
•
Powerful 16bit host chip with Ghost technology
operating system included
•
All pins on target device monitored by host
microcontroller
•
On-board SRAM memory for data storage
•
LEDs for Power, In-Circuit -Debug, In-Circuit -Test,
and Program
•
Lower operating voltage (9V)
Copyright © 2014 Matrix Technology Solutions Ltd
Advertisement
