The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Item check list Before starting, please check that all the following items have been included with Aputure DEC LensRegain. If anything is missing, contact your dealer immediately. DC IN...
Nomenclature 1. Adapter Lens mount index Camera mount index Camera mount (for MFT) Focal reducer Lens release button *Directed by the arrow Lens lock pin Contacts Connector 1/4” Thread Connector mount index 2. Control box OLED screen Power switch Charge / Remote / Update port Connector...
Page 5
3. Grip OLED screen Aperture wheel START/STOP button 1/4”socket Power switch Focus shifter A stop IRIS LOCK B stop Charge port Preparation 1. Open safe case Release the shifts on both sides to open the safe case. You need loosen the balance valve anticlockwise before if needed.
Page 6
2. Attaching 1) Align Lens mount indexes on the adapter and lens and turn the lens by the arrow until it snaps into place. (For Canon EF mount lens, please follow the index of red dot.) 2) Align the indexes on the adapter and camera and turn the adapter by the arrow until it snaps into place. BMD series Panasonic GH series 3) Align the indexes on the connectors, plug in the direction shown by picture.
Page 7
BMD series GH Series Panasonic GH series *Aputure DEC LensRegain is able to work while charging by connecting to USB cable which attached to an AC adapter (5V 1A). 4. Claw Clip The grip can be set on rocker, tripod, shoulder and other supporting systems.
Page 8
6. Charging Charge the grip and the adapter by connecting Charge & Update cable, which should be attached to an AC adapter (5V 1A). Charge & Update 5V/1A The battery icon will blink while charging When this icon shows, that means the battery is fully charged. * The grip will blink as follows: Showing low battery of the adapter Showing low battery of the grip...
Therefore, the screen will display the equivalent aperture(T), instead of aperture(f) . For example, if the aperture is set at f4, DEC LensRegain will display T2.8. * As for depths of eld, it still keeps original character of lens.
Page 10
5. Adjust aperture Dial < > to set your desired aperture in every 1/3 EV steps. Left for the minimum and right for the maximum. The OLED screens on both adapter and grip will display the f value. Aperture wheel Aperture Display 6.
Page 11
(Short press: open/close max aperture mode Tips and trouble setting 1. Please charge the Aputure DEC LensRegain within 3 minutes after the low battery icon appeared in case of unstable work. 2. Please charge for the grip before using it again if it was powered o because of low battery.
0.75x Dimension Φ37mm The list of tested compatible Lenses is below and more can be found on the o cial website: http://www.aputure.com/technique/DEC-LensRegain Canon EF 70-200mm f/2.8L IS II USM Canon EF 24-105mm f/4L II USM Canon EF 40mm f/2.8 STM Canon EF 50mm f/1.8 II...
Need help?
Do you have a question about the DEC LensRegain and is the answer not in the manual?
Questions and answers