Summary of Contents for Restech PLT Solas
- Page 1 User and maintenance manual for the PLT Solas ® This manual should be read before operating the PLT ® For easy registering, the information you need is the serial number for your PLT Solas ® The serial number is: Version: 01.06.2018...
- Page 2 Maintenance Procedure of the PLT Air Cylinder ......13 ® Always inspect the launching unit, rope, and projectile before use. Only use original parts made by Restech Norway. Make sure that the area you are launching to is clear and safe. The PLT Solas must always be treated as potentially ®...
- Page 3 Contact Information By opening the closing valve, air flows from the air cylinder through the Reduction Valve and into the chamber of the Base Unit. The pressure in this Restech Norway chamber is 75 bars (1088 psi). Postal Address Visiting Address...
- Page 4 Using the PLT Solas Using the PLT Solas Projectile ® ® Always use hearing protection when operating the PLT Solas ® 1. Screw the launching tube onto the launching unit (Fig. 1) 2. Open the Closing Valve for 5–10 seconds until the chamber is full (Fig. 2) CLOSE THE VALVE IMMIDIATELY WITHOUT USING EXCESSIVE FORCE.
- Page 5 Using the PLT Solas ® Trigger Safety knob Projectile Aim over the target while making sure that the PLT Solas Launching Unit is supported ® against something solid by using the Damper Pad on the PLT Solas Air Cylinder Cover. ®...
- Page 6 Aim away from any person and release the compressed air by pulling the trigger. Please use hearing protection. Remember to refill the air cylinder afterwards. Actions is Required If any issues arise during testing, such as leakage or damage to the unit, please contact Restech Norway AS.
- Page 7 If the Air Cylinder needs to be certified or tested, or shows signs of damage or 477. corrosion, please contact the nearest service station or Restech Norway AS. For filling to 207 bar (3000 psi), normally a yoke adaptor Found stamped on the bottleneck: ANSI -CGAV1/1989 is used.
- Page 8 Restech Norway AS www.restech.no...
Need help?
Do you have a question about the PLT Solas and is the answer not in the manual?
Questions and answers