Summary of Contents for Brähler Systems INFRACOM LKC50
- Page 1 ® INFRACOM Tray-setup lite for LKC50 Programming Tool Operating instructions Rev 1.51...
- Page 2 INFRACOM® is a registered trademark of Brähler ICS Konferenztechnik International Congress Service AG. All other trademarks and trade names are the property of their respective owners. Printed in Germany Should you have any questions regarding this manual please contact: Brähler ICS Konferenztechnik International Congress Service AG Auf der Alten Burg 6 D-53639 Königswinter, Germany...
-
Page 3: Table Of Contents
INFRACOM® IRX Tray Setup Content About this manual ....................4 Symbols ..........................4 Important tips ......................5 General information ....................... 5 Safety information ......................... 5 IRX Tray Setup ......................6 Installation ......................6 Cabling of LKC50 ........................7 IRX Tray Setup Program ......................9 Warranty ........................ -
Page 4: About This Manual
IRX Tray Setup INFRACOM® About this manual Symbols The meaning of the symbols and fonts used in this manual: Indicates an important note, if not minded, the functionality of the unit, the security of your data, or your health are put at risk. Taking special care when you see this symbol as indicates important information! Supplementary information, remarks, and tips follow this symbol. -
Page 5: Important Tips
INFRACOM® IRX Tray Setup Important tips General information Please read this manual carefully before starting operation. To avoid damages of the receiver please read the following tips for the use with disposable or rechargeable batteries carefully! Don’t use disposable and rechargeable batteries together in one receiver! You will invalidate the warranty and damage the receiver. -
Page 6: Irx Tray Setup
IRX Tray Setup INFRACOM® IRX Tray Setup This program allows adjusting various operating parameters of the IRX infrared receiver for up to 50 devices simultaneously in the TK50 charging tray. Just connect the LKC50 programming device between the power supply and the included AC charging adapter of the TK50 charging tray. The LKC50 programming device connects to a RS232 serial port of a PC or notebook. -
Page 7: Cabling Of Lkc50
INFRACOM® IRX Tray Setup Cabling of LKC50 Procedure: Remove the plug of the power supply from the charging tray TK50 and connect it with the programming tool LKC50. Connect the output of the programming device to the charging tray TK50. Connect the Sub-D9 connector to a serial port on your computer. - Page 8 IRX Tray Setup INFRACOM® To program multiple TK50 charging trays at once you may link multiple LKC50 programming devices. Thus even more than 50 IRX receivers can be programmed at once. The cabling is shown in the following diagram: IN FRACO M® IN FRACO M®...
-
Page 9: Irx Tray Setup Program
INFRACOM® IRX Tray Setup IRX Tray Setup Program Start the IRX Tray Setup Program from the program group “BRAEHLER”. The current setup will install both versions V2.6 for IRX with firmware 2.6 - 3.0 and a version V5.1 for IRX with firmware > 5.0 Depending on the version you start the following window appears to set up the operating parameters: For IRX versions 2.6 to 3.0 Please note the... - Page 10 IRX Tray Setup INFRACOM® 1) Max Channel: Use this option to set the highest available channel number on the IRX receiver. This prevents delegates to select higher channel numbers than being used in the meeting. However, the factory default for the number of available channels cannot be changed.. An IRX12 receiver can only be set to channel 11 (OR+ 11 channels).
- Page 11 INFRACOM® IRX Tray Setup 7) IR Band Mode: The new generation of INFRACOM receivers is now switchable between Band II (55kHz - 1335kHz) and Band IV (1935kHz - 3175kHz). The standardization body (DIN / IEC) has approved Band IV for analog and digital conference technology. This was necessary as dimmable fluorescent lights produce harmonics which can cause a disturbance to conference technology when transmitting with infrared light on Band II.
-
Page 12: Warranty
IRX Tray Setup INFRACOM® Warranty ® BRÄHLER ICS allows for the INFRACOM products a warranty period of 24 months, from date of delivery, for faulty materials and/or manufacturing faults. The warranty does not include rechargeable or disposable batteries, misuse, negligence, breakage, wrong installation, use outside the existing rules and any unauthorised modifications. -
Page 13: Contact Information
INFRACOM® IRX Tray Setup Contact information Head office Germany Brähler ICS Konferenztechnik International Congress Service AG Wahlfelder Mühle 3 53639 Königswinter, Germany P.O. Box 3264 53627 Königswinter, Germany T +49 (0) 2244 930-0 F +49 (0) 2244 930-450 www.braehler.com Rental service Wahlfelder Mühle 3 53639 Königswinter, Germany T +49 (0) 2244 930-200... - Page 14 IRX Tray Setup INFRACOM® Note Copyright by Brähler ICS...
- Page 15 INFRACOM® IRX Tray Setup note Copyright by Brähler ICS...
- Page 16 www.braehler.com T 02244 930-0 S4.2600...
Need help?
Do you have a question about the INFRACOM LKC50 and is the answer not in the manual?
Questions and answers