Related Manuals for FCS HWM PermaNET SU
Summary of Contents for FCS HWM PermaNET SU
- Page 1 Quick Start Guide: PermaNET SU Installation (Using HWM IDT). Warning: Before continuing, carefully read and follow the information in the “Safety Warnings and Approvals Information” document.
- Page 2 TABLE OF CONTENTS Prepare ..........................2 Deployment ........................2 Record logger deployment location / Site details ............6 Note(s): 1. Loggers must be pre-registered on DataGate. 2. User must be pre-registered on DataGate. Contact your System Administrator (or your HWM Sales representative) to obtain your server URL, username and password information, etc.
- Page 3 REPARE 1. Install required apps Install “IDT”. Install “HWM Deployment App” onto a mobile phone Links: IDT: HWM Deployment App: Google Play and the Google Play logo are trademarks of Google LLC. 2. Configure IDT app and Login Launch IDT.
- Page 4 3. Wake Logger Hold strong magnet in position shown. Wait 8 – 10s. • Logger stays awake for 120s, waiting for IDT to communicate. Communication with phone remains open • for 600s after last use. 4. Read barcode / Bluetooth scan Tap “Barcode Scan”...
- Page 5 6. Set Call-in Settings “Call Settings”. Set network details for your SIM provider. Set your DataGate destination Call-in daily at set times. Save battery – Do not call if Set your required latest data already sent OK. logger call-in details Times at which to call with data.
- Page 6 8. Check CSQ level “Signal Test” Fit lid of chamber and check network CSQ level. Summary of CSQ levels is shown below: Poor. (The logger may be able to register with network but will not be able to send or receive data reliably). 8-14 Acceptable (Depending upon the ambient conditions data transmission may be possible.
- Page 7 RECORD LOGGER DEPLOYMENT LOCATION ITE DETAILS 1. Begin Deployment location recording “Deploy Device” “Configure server URL…” Add details “Test Connection”. and confirm OK result. Add Username and Password “Login”. Select “Options” tab. To sync with DataGate… Tap “Last sync with server”. 2.
- Page 8 3. Obtain GPS location of site. “GPS Coordinates” Wait for map to load. Position “X” onto location of site of deployment. (Move map using touch-screen. Zoom map if required). When finished, tap on “Set”. GPS locations are set. Estimate of address is set (editable).
- Page 9 “New photos”. “Add from camera” Take photos of installation site. “Done” “Save” 5. Upload to DataGate Upload the deployment data to Datagate using the Upload icon (shown). This uploads location details and also any photographs. Note: It is important to sync frequently 6.
- Page 10 HWM-Water Ltd Ty Coch House Llantarnam Park Way Cwmbran NP44 3AW United Kingdom +44 (0)1633 489479 www.hwmglobal.com ©HWM-Water Limited. This document is the property of HWM-Water Ltd. and must not be copied or disclosed to a third party without the permission of the company. Copyright reserved. MAN-155-0002-A...