Robert Abbey PEEK Assembly Instructions

ASSEMBLY INSTRUCTIONS FOR YOUR

IMPORTANT SAFETY INSTRUCTIONS:

* This lamp has a polarized plug (one blade is wider than the other) as a feature to
reduce the risk of electric shock. This plug will fit in a polarized outlet only one
way. If it does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do NOT alter the plug.
* Do not use with an extension cord unless the plug from the lamp can be fully
inserted into the extension cord receptacle.
* Switch power off and remove plug from the wall outlet before replacing the bulb.
* This lamp is UL rated for dry locations.
ASSEMBLY INSTRUCTIONS:
NOTE: Do not connect electricity until lamp is fully assembled.
1. Unpack all parts and remove packing materials. Place lamp base on a level
surface.
2. Install one 60W max., type A, medium base bulb into the socket (C).
3. Slide glass (B) over socket (C) until it sits securely inside column (D).
4. Slide shade (A) over glass (B). Please note, shade will fit over glass in two
different ways. Fig. 1 on the following page illustrates glass shown. Fig. 2
illustrates glass covered, resulting in uplight only. Flip shade to achieve desired
look.
5. Remove protective plastic from plug (E).
6. Insert plug (E) into wall outlet.
7. Control power to lamp by lightly touching column (D).
**To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners.**
PEEK FLOOR LAMP
(E)
(A)
(B)
(C)
(D)
599
Page 1 of 2