LG Styler S3RERB Service Engineering Manual page 11

Hide thumbs Also See for Styler S3RERB:
Table of Contents

Advertisement

INSTALLATION LOCATION REQUIREMENTS
WarNiNg
Read all installation instructions completely before installing and operating the
Styler. It is important to review this entire manual before installing and using the Styler.
The installation requires:
y A grounded electrical outlet located within
2 ft. (61 cm) of either side of the appliance.
WarNiNg
Do not install or store the Styler in an area where it will be exposed to water and/or
weather. Failure to follow this warning could result in risk of electric shock, injury, or product
damage or malfunction.
Clearances
cautioN
The floor must be level, with a maximum slope of 1 inch (2.5 cm) under the Styler. If the
slope is greater than 1 inch (2.5 cm), the appliance cannot be leveled properly.
Do not install the Styler on a hollow or flexible platform. Doing so may cause excessive
noise and vibration and result in damage or injury if the product tips over.
Recommended Installation Spacing
15
56½ in.
(1435 mm)
16
/
in.
5
16
(415 mm)
/
in (385 mm)
5
32
y A sturdy floor to support the total ap-
pliance weight of 183 lbs (83 kg). The
combined weight of any other laundry ap-
pliances should also be considered.
2
/
in.
3
64
(52 mm)
23 in.
(585 mm)
11
72
/
in.
13
16
(1850 mm)

Advertisement

Table of Contents
loading

Table of Contents