MODEL FMP 100-200 PROOFER OPERATION AND SERVICE MANUAL Table of contents PAGE Installation Safety information Features / Controls Operating instructions Technical Parts / Electrical Schematic Friedrich Metal Products Co., Inc. 6204 Technology Drive Browns Summit, NC 27214 (336) 375-3067...
INSTALLATION SPECIAL NOTICES o Your Friedrich Proofer has been thoroughly tested and checked before shipping to your store. Upon receipt of crated unit unpack carefully and inspect for damages. File any claims that may be required with the shipping company immediately. If necessary to replace damaged parts with new ones, contact FMP via phone(336)-375-3067 or FAX (336) 621-7901 to expedite shipment.
Page 5
INSTALLATION REOUIREMENTS. a. Electrical Service - All FMP Proofers are ARL listed. Customers are responsible for complying with local electrical codes when installing Proofers purchased through FMP. All Proofer models require isolated electrical service for operating the blower/control and heating systems. o Refer to electrical schematic for requirements on specific models.
SAFETY INFORMATION 1. The frame of unit MUST be electrically grounded at all times. See "Installation - electrical." FAILURE GROUND THIS UNIT RESULT ELECTRICAL SHOCK. 2. DO NOT use aluminum foil or any other protective material on inner liner surfaces or food racks.
Model FMP 100 - 200 PROOFER PROOFER CONTROLS AND COMPONENTS TEMPERATURE CONTROL - To be set between 90 and 110 degrees F. depending on local conditions and product to be pr oofed. TEMPERATURE INDICATOR - Light, to show heating elements are operating to b ring temperature in proofer to set value.
OPERATING INSTRUCTIONS REFER TO PAGES ON PROOFER CONTROLS AND COMPONENTS AS NEEDED FOR DETAILS ON LOCATION AND FUNCTION OF FEATURES. STEP 1 - Set power switch to “On” position. Listen for and observe the following: Fan starts and runs Power indicator (built into switch) lights red. STEP 2 - Depending on local conditions and products to be proofed, set humidity and temperature controls as follows: a.
Page 9
The points of connection for electrical service and plumbing facilities are shown for each Proofer model in the installation diagrams on page 7 and 8. The installation diagrams also give details of the physical features of each Proofer model for use by installation planners and installers. These physical features include dimensional data, uncrated weights, and clearances required for running and connecting electrical and plumbing lines.
Need help?
Do you have a question about the FMP 100-200 and is the answer not in the manual?
Questions and answers