Advertisement
2.
Line up the holes in the upper and middle
support plates on the back side. Secure the
middle holes with M10x35 bolt and washer from
one side and washer and nut from the other
side. Fix the support leg A simultaneity when
secure the holes on both edge by insert the
M10x35 bolts and washers from one side, and
slide the support legs A on the bolts from the
other side, tighten down with washers and nuts.
It is the same way to fix support leg B with the
lower and middle support plates.
Insert the support legs A into the sleeves which
3.
are mounted on the tilted support legs 1 with
M10x40 bolts and nuts. Screw off the nuts and
washers, then slide the support legs 2 on the
bolts, tighten down with washers and nuts
previously screwed off.
Insert the support legs B into the sleeves which
4.
are mounted on the tilted support legs 2 with
M10x40 bolts, washers and nuts.
Align up holes in the wheel support leg and the
5.
lower support plates, and then secure them
with six M8x30 bolts from outside, washes and
nuts from inner side.
6.
Align up holes in the wheel support leg and the
wheel shaft, and then insert the M8x45 bolts
with washers from the bottom, tighten down
the nuts from the other side.
Mount the reducer bracket on the lower support
7.
plates with three M12 bolts.
M6
16
1.
Secure the wheels on the wheel shaft with the
wheel caps.
2.
Wrap the belt on the driving and driven belt
pulleys over the machine, and link it up with
buckle.
3.
Fix the switch bracket on the middle support
plates with four M6x16 bolts, followed by
washers and nuts.
Adjusting
After you finished the assembly, please adjust the
machine as follows.
M10X50 Bolt
M10 Nut
1.
You should fix the adjusted screw rod firstly;
adjust this screw rod until the belt not slippery.
2.
Loose the three M12 nuts under the reducer
bracket and the two M10 nuts at the other side
of the bracket wall, then adjust the two M10x50
bolts until the driving and driven belt pulley
parallelized and the belt run on its way then
tighten down the M12 and M10 nuts.
b
4
Adjusted
Screw Rod
M12 Nut
Advertisement
