Advertisement
INSTALLATION:
1. Loosen trunnion arm bolts, adjust to desired angle and fasten the bolt using hex key.
Key Size
5mm
6mm
8mm
2. Mount the fitting to wall or ground and connect to power supply.
3. Turn on power.
MAINTENANCE:
The supply must be isolated before opening or accessing the luminaire. Product maintenance is critical to the product designed
performance. The product is to be maintained in accordance with the manufacturer's instructions. For the latest product
maintenance guides please go to www.davislighting.com. Davis Lighting is not responsible for any product not maintained in
accordance with the recommended procedure or intervals. The light source of this luminaire is non-replaceable; if the light
source should become faulty or expire then the entire luminaire will need to be replaced. Products supplied with visors or covers
must not be operated with a damaged visor or cover; it is recommended damaged visors or covers be replaced by a competent
person immediately.
Warning: Maximum loading of earth leakage and circuit protection device.
Note
The maximum number of ballasts/drivers connected to earth leakage circuit protection device shall not be greater than 6
units for fixed output on MCB 16A or that as recommended by the protective device supplier/manufacturer whichever is the
smaller number.
The maximum loading of automatic circuit breakers shall not be greater than those shown in the table supplied by the
control gear manufacturer or that as recommended by the protective device supplied/manufacturer whichever is the
smaller number.
Model
10W / 20W / 30W / 50W
100W
150W / 200W
Advertisement
