Operating Instructions - Kobalt KFL 224B-03 Manual

OPERATING INSTRUCTIONS

1. To Attach Battery Pack
a. Align the raised portion on the battery pack
with the grooves on the bottom of the tool, then
slide the battery pack onto the tool, as shown.
b. Make sure that the latches on the battery pack
snap into place and the battery pack is secured
to the tool before beginning operation.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper assembly of
the battery pack can cause damage to internal
components.
To Detach Battery Pack
a. Press the battery-release buttons to release the battery pack.
b Pull upward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always remove the battery when
the tool is not in use or when carrying the tool at your side.
2. ON/OFF Switch
a. To turn the floodlight ON, press the ON/OFF
switch (A). The floodlight will be turned on at
maximum brightness.
b. The light has three luminance settings. To
reduce the brightness successively, press the
ON/OFF switch again and then a third time.
c. To turn it OFF, press the ON/OFF switch again:
a fourth time.
NOTICE: Do not continue to press the ON/OFF
switch after the worklight has been automatically
switched off. This could damage the battery.
WARNING
• When the battery charge is low, the light will cycle from maximum brightness to lowest
brightness, back to maximum brightness, and then turn off. Charge the battery to avoid
battery damage.
Battery release
1
buttons
2
7
A