Advertisement
Quick Links
#113133
Extension Handle
*Extension handle is shown attached to the 113132 seed
spreader. Items are sold separately.
©2015 FarmTek
®
All Rights Reserved. Reproduction
is prohibited without permission.
Revision date: 02.11.15
*
Adjusters
#113132 FodderPro 3.0
Hand-Held Seed Spreader
Handle
Adjuster
Roller
1
Advertisement
Related Manuals for FarmTek FodderPro 3.0
Summary of Contents for FarmTek FodderPro 3.0
- Page 1 #113133 Extension Handle #113132 FodderPro 3.0 Hand-Held Seed Spreader Handle Adjusters *Extension handle is shown attached to the 113132 seed spreader. Items are sold separately. Adjuster Roller ©2015 FarmTek ® All Rights Reserved. Reproduction is prohibited without permission. Revision date: 02.11.15...
- Page 2 #113132 FodderPro 3.0 Seed Spreader The steps below show how to quickly set the 113132 FodderPro 3.0 Seed Spreader to spread seed at the desired depth. Use pliers to turn wing nuts if needed. A tape measure or ruler is also needed to set depth.
- Page 3 #113132 FodderPro 3.0 Seed Spreader continued— 4. Verify that both ends of spreader ski remain tight against flat 5. Move to the other end and repeat steps to set roller height. surface. Roller 6. Recheck roller height at both ends. Dimensions must match.
- Page 4 #113132 FodderPro 3.0 Seed Spreader continued— Dimension is equal to the required seed depth. Set screed even with roller. Spreader Ski 9. Adjust screed at both ends to be even with bottom of roller. 8. Loosen two spreader screed wing nuts to allow for spreader After dimension is set, tighten wing nuts.
- Page 5 The 113133 extension handle, when attached to the 113132 hand-held seed spreader, allows you to spread seed in a fodder channel without removing the channel from the fodder frame. If the 113133 FodderPro 3.0 Seed Spreader Extension Handle was purchased to convert the hand-held spreader, complete the steps below to attach handle.
- Page 6 #113133 FodderPro 3.0 Seed Spreader Extension Handle ATTACH EXTENSION HANDLE—CONTINUED 7. Remove the 5/16" J-bolt and two 5/16" nuts 8. Insert bolt and nut through eye bolt and 9. Ensure that J-bolt end is parallel with handle from packaging and thread one nut onto bolt.
- Page 7 #113133 FodderPro 3.0 Seed Spreader Extension Handle Below are basic steps showing how to use the seed spreader with attached extension handle. Use of hand-held spreader may require removal of fodder trays from fodder rack to evenly spread the seed.