Lemon Stabilizer Plus Quick Start Manual

Lemon Stabilizer Plus - Quick Start Guide
This Quick Start guide outlines the basic setup of the Lemon Stabilizer Plus with a generation 2 or later Spektrum
transmitter. For other transmitters and additional details see:
Essential Instructions
https://www.rcgroups.com/forums/showatt.php?attachmentid=11910025&d=1554438806
and the Reference Guide
https://www.rcgroups.com/forums/showatt.php?attachmentid=9835599&d=1488573620
Important: As supplied, stabilization is turned OFF. To turn ON, see table below.
1)
Set up a new model on your transmitter. It must be set up as a conventional model with ailerons (single or
dual) and normal rudder and elevator. Even if your model has a V-Tail or has Elevons (e.g. is a Delta), do not
do any V-Tail or Elevon mixing in the transmitter.
2)
Set the 3 white switches 4, 5 and 6 as shown in the table below. A pin is a good tool to flick the switches On
or Off. Make sure they are firmly at one side or the other.
Model configuration
1x Aileron servo, conventional tail
2x Aileron servos, conventional tail
1x Aileron servo, V-Tail. Tail servos connect to E and R
2x Aileron servos, V-Tail. Tail servos connect to E and R
Elevons or Delta wing. Servos connect to A and E
The photo above shows how the output pins support the various functions.
Channels 1 - 4 are the primary controls, in order: Throttle, Aileron, Elevator, Rudder.
Channel 5 (Gear) controls Stabilization mode and is not to be connected to a servo.
Go to Channel Assign, NEXT, and set 5 Gear: to a suitable three-position switch, e.g. B or D.
Channel 6 (Aux1) may be used for Retracts or for the second servo in a dual Aileron setup.
Channel 7 (Aux2) can support Flaps and doubles as the Bind pins.
Channel 8 (internal to the StabPlus) is used for Master Gain (knob) on an 8-channel transmitter.
Aircraft type
Wing Tail
Normal Normal ON
Dual Ail Normal ON
Normal Normal Off
Dual Ail Normal Off
Normal Normal ON
StabPlus Quick Start v1
Switches
4 5 6
ON Off
ON ON
ON Off
ON ON
Off Off
Page 1 of 4