Sony MEX-D30 Service Manual page 6

MEX-D30/V30
Foot brake type
Parking brake switch cord
1
3
Face the hook inwards.
1
A
B
Precautions Removing the protection
collar and the bracket
Choose the installation location carefully so that the
unit will not interfere with normal driving operations.
Avoid installing the unit in areas subject to dust, dirt,
Before installing the unit, remove the protection
excessive vibration, or high temperature, such as in collar and the bracket
direct sunlight or near heater ducts.
1
Remove the pre-installed screws.
Use only the supplied mounting hardware for a safe and
2
Remove the protection collar
secure installation.
Pinch both edges of the protection collar
push outwards, then pull out.
Mounting angle adjustment 3
Remove the bracket
Insert both release keys
Adjust the mounting angle to less than 30°.
the unit and the bracket
Pull down the bracket
Connecting the parking brake
to separate.
lead
Mounting example
Be sure to connect the parking brake lead (light green) of
the power supply connection cable to the parking
Installation in the dashboard
brake switch cord. The mounting position of the parking
brake switch cord depends on your car. Consult your car
Notes
Bend these claws outward for a tight fit, if necessary (
dealer or your nearest Sony dealer for further details.
Make sure that the 2 catches on the protection collar
engaged in the slots of the unit (
6
Hand brake type
2
2 3
Claws
How to detach and attach the
front panel
Before installing the unit, detach the front panel.
from the unit.
-A To detach
.
Before detaching the front panel, be sure to press
and
Press , then slide the front panel to the right side,
and pull out the left side.
.
together between
until they click. -B To attach
, then pull up the unit
Engage part of the front panel with part
as illustrated, and push the left side into position until it
clicks.
Warning if your car's ignition
has no ACC position
-2).
Unnecessary battery drainage will occur if the unit is
are properly
wired directly to a car ignition system that does not have
-3).
an ACC position. To avoid battery drainage, install a
suitable switch on the ACC line.
Parking brake switch cord
Dashboard
Fire wall
Reset button
When the installation and connections are completed, be
sure to press the reset button with a ballpoint pen, etc.
.
of the unit,
Power connection diagram
The auxiliary power connector may vary depending on
your car. Check your car's auxiliary power connector
diagram to make sure the connections match correctly.
There are two basic types (illustrated below). You may
need to switch the positions of the red and yellow leads of
the unit's power supply connection cable .
After matching the connections and switched power
supply leads correctly, connect the unit to the car's power
supply. If you have any questions and problems
connecting your unit that are not covered in these
instructions, please consult your car dealer.
Auxiliary power connector
Red Red
Yellow Yellow
4 Yellow Continuous power supply 7 Red
Red Red
Yellow Yellow
4 Yellow Switched power supply 7 Red Continuous power supply
Switched power supply