Table of Contents
Advertisement
Available languages
Available languages
mation is for your safety and the protection of the
device.
» The blade is made of wear-resistent material.
» The blade is not sharp or pointy as an usual knife.
» The cutting width of this product is about 8 mm.
Calculate this material loss when cutting laminate.
The cutting mark should be on the side of the
laminate, that will be used later.
Using the product
» Connect the handle to the blade by using the 3
provided screws (2), the 6 shims (3) and the 3
provided locking nuts (4).
» Tighten the screws and nuts fast enough. The blade
should have a resistance when pushed down to
avoid an unintentional down-folding.
» Always put the tread surface of the laminate
upwards into the cutter. The cutting mark should
also be at the tread surface. The upper edge of
the material will have a clean cut. The edge at the
backside may gets some material fractures.
» Lay out the laminate exactly at the guide bridge to
get an angle of 90°. Stabilize the other end of the
laminate with the provided support base.
» The cutting width of this product is about 8 mm.
Calculate this material loss when cutting laminate.
The cutting mark should be on the side of the
laminate, that will be used later.
» By evenly and powerfully pushing down the handle,
the blunt blade cuts the laminate. Check if tongue
and groove are bend after the cutting process.
Correct the position of both if necessary.
18
Cleaning and Maintenance
Always check the technical safety of the product
before use, for example check if the screws sit tightly.
If a secure usage is not longer guaranteed, do not use
the product any more and make sure others don't use
it as well.
A safe usage is not guaranteed under the following
circumstances:
» Parts of the product are loose.
» Parts of the product are bend.
» The product was stored under unfavourable
conditions for a long time.
» The product was exposed to high stress during
transport.
All persons installing, handling or using this device
should be qualified to do so and follow the instruction
manual.
If you pass on this product, always use the original
packing to secure the product from any damage. Also
pass on the instruction manual. It includes important
information for safety and usage of this product.
Trouble Shooting
Problem
Cause
The handle
Remains of
doesn't move
wood are stuck
properly and
in the laminate
smoothly.
cutter.
Solution
Clean off the
wood
remains.
19
Advertisement
Table of Contents
