Ohm Acoustics MicroWalsh Manual

Congratulations! You are now the proud new owner of a pair of Ohm MicroWalshs! This is the smallest Walsh speaker we
have ever made, but it boasts the same features as its big brothers and sisters! You will hear for yourself the open, airy
treble; the dramatic bass; the open midrange for natural voice reproduction; and the wide sweet-sweep that allows
listeners to hear the same, incredibly detailed three-dimensional stereo imaging from almost any position in the room!
Following are the simple instructions for installation. It will take some experimenting with room placement to optimize
the performance in your home. Do this at your leisure with a variety of music. No one set-up is best for all rooms and
music.
Connecting the loudspeakers:
The Ohm MicroWalsh is a floor standing loudspeaker equipped with gold plated binding posts on the back of the
cabinet. These terminals will accept any standard type of wire connector, including bare wire.
Before connecting your loudspeakers, unplug your receiver/amplifier and make sure you have the right kind of wire.
We strongly recommend 12 AWG speaker wire.
Strip no more than ½" of insulation off both ends of the speaker wire with wire strippers, scissors, or a sharp knife .
By twirling the exposed ends between your thumb and forefinger, you can prevent stray strands of wire from shorting
out the terminals.
Leave lots of slack in the speaker wire until after you decide where the loudspeakers should be placed, so the
components can be moved around without straining the connections.
Note that one side of the speaker wire has a ridge or a printed stripe running its entire length, while the other side is
left unmarked. To assure in-phase operation, make sure to connect the marked side of the speaker wire with the red
(positive) terminal on the receiver on one end and the red binding post on the back of your MicroWalsh on the other
end. Then connect the unmarked side of the speaker wire to the negative (ground) terminal on your amplifier on one
end and the black binding post of your MicroWalsh on the other. It is important that you follow this procedure exactly
for both loudspeakers, or else they will play out of phase.
MicroWalsh
Dimensions
Recommended Amplifier
Impedance (typical)
Frequency Response
Sensitivity @2.8 Volts
Recommended Room Sizes
Ohm Acoustics Corp.
76 Degraw Street
Brooklyn, NY 11231
ohmspeaker.com
` 6 x 6 x 36 in
35-125 watts
4 Ω
47 - 20,000 Hz
85 dB
600-1000 cu. ft.