Storage And Care - Parkside 100279963 Installation And Safety Precautions

Use
Figure P
Set the bench on its legs. Push the
joints of the struts down until they are
stretched horizontally. This gives the
bench stability and ensures it is ready
for use.
Figure Q Functionality:
Simultaneously turn both cranks to
move the rear clamping plate.
This adjusts the size of the bench
when you are using it as a workbench.
This method is also used to clamp the
workpiece when using the bench as a
vice.
Figure R
For clamping workpieces:
Insert the clamping jaws into the
clamping plates at the appropriate
position.
Figure S Clamping workpieces with parallel
surfaces:
Rotate the clamping jaws so that the
ribbed surface hold the workpiece.
Figure T Clamping round workpieces:
Rotate the clamping jaws so that the
horizontal grooves hold the workpiece.
Figure U
Using as a workbench:
Remove the clamping jaws. Set the
clamping plates to create a bench
surface of an appropriate size.

Storage and care

Care
• C lean the bench carefully after each use. Use a
brush or a damp cloth. Do not use aggressive
or scouring cleaning agents. Allow the bench
to dry fully before storing.
• Occasionally lubricate all moving parts with
ordinary grease.
Storage
Figure V
Close the clamping plates up
together.
Figure W
Pull the joints of the struts upwards
to angle them.
Figure X
Push the legs together at the
bottom. This swivels the bench-top
upwards.
Figure Y Push the legs together as far as
they will go. The bench is ready for
storing. Choose a dry location for
storage. Store the bench flat on the
ground, or leaning against a wall in
such a way that it cannot fall.
Disposal
• D ispose of the packaging materials according
to local regulations.
• Once the bench has reached the end of its
lifetime, recycle it in accordance with local
regulations. Do not put into the household
waste.
13