Install Leveling Legs; Install Shelves - Whirlpool Gladiator GarageWorks Extra Large GearBox Cabinet Assembly Instructions Manual

4. Using two Phillips-head screws, attach each back panel to the
panel above.
NOTE: Using three Phillips-head screws, attach the last back
panel (P8) to the cabinet bottom (P3).
5. Completely tighten all back panel screws starting with the sides
and continuing with the top, middle and bottom.
6. Using the Allen wrench (provided), completely tighten all 24
cabinet bolts and nuts.
P1
P3
A. Cabinet bottom

Install Leveling Legs

1. Place the cabinet on its side.
2. Screw a leveling leg (P4) into each of the four rivet nuts located at
the corners of the cabinet as shown.
P1
P3
A. Leveling legs
3. Stand the cabinet upright.
4. If you have not already, fasten the two bolts at each front corner,
of the cabinet frame. Completely tighten all the cabinet bolts and
nuts.
4
P2
P1
A
P4
A

Install Shelves

F3b F4
F3b Phillips-head screw (12)
F4 Small flange nut (12)
IMPORTANT: Use the pair of holes located in the middle of the
cabinet sides to install a center shelf (P5), so the doors will close and
lock. The other two shelves may be installed where desired.
1. Place a shelf (P5) so that the holes in the ends are aligned with
the pair of holes in the middle of the cabinet sides.
NOTE: Make sure the hole in the center of the long shelf edge is
facing out.
2. Using two bolts and nuts per side, fasten the shelf (P5) to the
sides (P1).
3. Insert the door catch pin (F5) into the hole in the front edge of the
shelf. Use ¹¹⁄₃₂" wrench to fasten it with the star nut (F6).
P1
A
B
A. Door catch pin and star nut
B. Middle pair of holes in cabinet side
4. Determine where you want to place the other two shelves (P5).
Align the holes in the shelf ends with the holes in the cabinet
side.
NOTE: Make sure the hole in the center of the long shelf edge is
facing the cabinet front.
5. Using two bolts and nuts per side, fasten the shelves (P5) to the
cabinet sides (P1). Completely tighten the nuts.
F5 F6
F5 Door catch pin (1)
F6 Star nut (1)
P2
P1
P5
P3