Advertisement
2. INTRODUCTION & SPECIFICATIONS
Manufactured from corrosion resistant materials with stainless steel body and motor case. fitted with automatic cut-out. Minimum water depth
of 30mm. Designed for clean water although these pumps will accept small particles up to 5mm. Suitable for the effective drainage of cellars,
sinks, cisterns, baths and the general transfer of water.
Model No: ........................................................................................................................................ WPS250A
cut-out: .............................................................................................................................................Automatic
outlet o/D ...................................................................................................................... 32mm (1"BSP )/24mm
Maximum output: ...................................................................................................................250ltr(54gal)/min
Maximum Head: .........................................................................................................................................8mtr
Maximum running cycle (hr): .................................................................................................................. 3 in 6
Motor Power:: .......................................................................................................................................... 600W
Supply: ...................................................................................................................................................... 230V
fig.1
3. OPERATING INSTRUCTIONS
WARNING! Ensure you read, understand and apply safety instructions.
3.1.
fit an appropriate discharge pipe to pump outlet and secure with a clip. Ensure the diameter of the discharge pipe is the same as, or
greater than, the outlet diameter. A smaller pipe will adversely effect the pump flow rate.
3.2.
Position the pump in the water and place the outlet pipe securely in the discharge receptacle or area. We recommend the pump is
submerged with its discharge outlet facing up to release any trapped air.
3.3.
Plug the pump into the electrical mains supply and switch on.
The pump will automatically turn on as the level of water rises (fig.1.A). As water level lowers, the float will automatically switch the
pump off as it reaches the minimum height (B). The float may be adjusted by shortening or lengthening the cable. The pump will
switch on if the water level is up to or above the maximum length of the float cable. To function correctly the float must move freely.
Ensure that the float can do so and that the cable is not restricted. check that the pump and discharge are working correctly.
3.4.
The water into which the pump is placed will act as the motor cooling agent. for this reason the pump must remain submerged at all
times. Should the pump have to be used in shallow water DO NOT operate for more than 10 minutes. failure to follow this rule will
damage the unit and will invalidate your warranty.
NOTE: See fig.2 to determine minimum clearance required if using the pump in a restricted area e.g: a sump or well
© Jack Sealey Limited
Original Language Version
fig.2
Advertisement
