Advertisement
WiMEA Owner`s Manual
Please see this section before contacting support. If this section does not solve your problems, please
Installation
System
operations
Troubleshooter
contact support by seeing: www.fell.no/support
No existing kill switch wires in my boat/from my engine
Contact your local boat workshop or FELL support for guidance on how
to install WiMEA in your boat.
No existing power source
Install a suitable power source (10 - 32Vdc). We recommend that this is
done by skilled or professional personnel only.
The wires on the Boat Unit are not long enough to reach my power source /
battery
Extend the wires using at least 20 AWG (0.75mm2) wire gauge and butt
splices in the correct size.
The system disconnects when I leave my boat
This is normal behavior as the advanced WiMEA8
-
automatically detects when you are too far out of range or has fallen
into the water, and disconnects.
No reaction from the Boat Unit when clicking the MOB Unit
Pair your MOB Unit with your Boat Unit
Cannot pair successfully: change the battery in your MOB Unit
Cannot connect/pair: switch OFF the main power source to the Boat
Unit, wait 10 seconds before switching it on.
Try to connect/pair again
Connection/pairing still not working: contact FELL support.
The engine won´t start even when connected successfully to the Boat Unit
Make sure the correct wires were chosen when the Boat Unit was
installed. Please see the section Installing FELL WiMEA for instructions
on how to properly install your WiMEA System.
Try to pair/connect another MOB Unit if available
Contact FELL support
Protocol
®
Advertisement
