Do you have a question about the 45074 and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Stark 45074
Page 1
50’ 1/2” 250W ELECTRIC SEWER SNAKE DRAIN AUGER CLEANER ITEM: 45074 OWNER’S MANUAL AND SAFETY INSTRUCTIONS SAVE THIS MANUAL: KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY, OPERATING, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES. WRITE THE PRODUCT’S SERIAL NUMBER ON THE BACK OF THE MANUAL NEAR THE ASSEMBLY DIAGRAM (OR MONTH...
IMPORTANT SAFETY INFORMATION GENERAL SAFETY WARNINGS Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. SAFETY The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur.
Page 3
IMPORTANT SAFETY INFORMATION Stay alert, watch what you are doing and use common sense when operating this tool. DO NOT use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury.
ELECTRICAL SAFETY INFORMATION Be aware of possible damage to the drain lines that may result from the discovery of roots and obstacles. To prevent electric shock and death from incorrect grounding wire connection. Check with a qualified electrician if you are in doubt as to whether an outlet is properly grounded. 1.
PRODUCT INFORMATION SEALED AIR FOOT FRAME SWITCH BELT GAURD KNOB HANDLE LOCKING KNOBS ROTATION SWITCH TOOL TRAY BELT GAURD TENSION KNOB DRUM POWER FEED LEVER CABLE WHEEL Assembled Product Dimensions (L x W x H): 23.00 x 17.50 x 36.00 Inches FEATURES This Portable Drain Cleaning Machines clears lines from 1”...
Page 6
ASSEMBLY NOTICE: If the cause of the obstruction is unknown, use the bulb cutter to explore the obstruction. If possible, retreive a piece to inspect. Once you can see the cause of the obstruction, select the appropriate tool for the job. Run the smallest available tool through the blockage to allow the backed up water to flow and carry away the debris as the drain is cleaned.
Page 7
SET UP WARNING: Before each use, inspect the drain cleaner and correct any problems to reduce risk of serious injury from electric shock, twisted or broken cables, chemical burns, infections and other causes and prevent drain cleaner damage. WARNING: Read and adhere to the following guidelines to prevent serious personal injury and property damage.
Page 8
SET UP 18. Press the foot switch and note the direction of rotation of the drum. if the foot switch does not control the cleaner’s operation, DO NOT use the machine until the foot switch has been repaired. 19. The drum should rotate clockwise when seen from the front of the drum. It wil match the drum direction shown on the warning label and the arrows molded onto the drum.
Page 9
SET UP 14. Verify the electrical outlet is properly grounded. A three oring or GFCI outlet may not be properly grounded. If in doubt, have the outlet inspected by a licensed technician. Install the tool to the end of the cable. Slide the base of the cutter tool into the slot at the end of the cable.
OPERATION RETREIVING DRAIN CLEANER CABLE 1. Once the drain is clear, turn on the faucet or use a hose to flush the debris out. NOTE: Pay attention to the water level. There could be blockages further down the drain. 2. Set the power switch to the OFF position and unplug the machine. 3.
MAINTENANCE Turn the power switch OFF and unplug the drain cleaner before performing any maintenance. ALWAYS wear safety goggles and gloves while performing any maintenance. CLEANING DRAIN CLEANER CABLES 1. Thoroughly flush the drain cleaner cables with clean water after every use. 2.
WARRANTY PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.
Need help?
Do you have a question about the 45074 and is the answer not in the manual?
Questions and answers