Advertisement
3.
ASSEMBLY
3.1
Take the 4 short rods from the two part connectors (N) and insert one into each hole at either end of the leg braces (A) as shown in
fig.1. Each rod has a screwdriver slot in one end. Use this slot to rotate each rod so that the slot is in line with the overall length of the
leg brace.
3.2
Take the lefthand end frame (B) and join it to the righthand end frame (C) using one of the cross braces (A) as shown in fig.2. Insert
a long socket cap bolt from the two part connector (N) through each end frame and into the leg brace. Using the 6mm Allen Key
provided rotate each bolt so that it picks up the threaded hole through the short rod. Continue to rotate until the end frame pulls up
tight against the end of the leg brace.
3.3
Take the shelf (D) and position it between the end frames so that its lower edge fits into the slot on the inside face of the first leg
brace as indicated in fig.3. Take the other leg brace (A) and place it into position between the end frames so that the edge of the shelf
fits into the slot on the inside face of the leg brace. Retain the leg brace with the remaining long socket cap bolts as shown in fig.4.
3.4
Spread some protective material on the floor (e.g. packaging cardboard) and place the bench top (F) face down on the material.
Attach
the two draw runners (E) to the underside of the bench top in the positions shown in fig.5 using the four screws (P).
3.5
Turn the end frame/shelf assembly upside down and place it on top of the bench top in the position shown in fig.5. Fix it down using
the four large hex headed screws (O) and four washers (Q) provided.
AP1520 - 1 - 14/09/06
Advertisement
