Table of Contents
Advertisement
Operating Instructions
®
Busch-Infoline
Pos: 44 /#Neustruktur#/Online-Dokumentation (+KNX)/Überschriften (--> Für alle Dokumente <--)/2. Ebene/A - F/Alarmverhalten mit Steckbrücke einstellen @ 25\mod_1341307557695_15.docx @ 221023 @ 2 @ 1
7.5
Setting alarm behaviour with jumper
Pos: 45 /#Neustruktur#/Online-Dokumentation (+KNX)/Montage/Infoline/Alarmverhalten 1531-1538 @ 25\mod_1341324839722_15.docx @ 221672 @ 22 @ 1
Fig. 4:
Busch moisture alarm insert 1531 U
Position
Jumper top
Jumper bottom
Pos: 46 /#Neustruktur#/Online-Dokumentation (+KNX)/Überschriften (--> Für alle Dokumente <--)/2. Ebene/P - R/Rücksetzmodus mit Steckbrücken einstellen @ 26\mod_1341562748726_15.docx @ 222994 @ 2 @ 1
7.6
Adjusting the reset mode with jumpers
Pos: 47 /#Neustruktur#/Online-Dokumentation (+KNX)/Montage/Infoline/Rücksetzmodus 1531-1538 @ 26\mod_1341562816256_15.docx @ 223007 @ 2 @ 1
Fig. 5:
Busch-Leakage guard insert 1531 U
Position
Plug-in jumper inserted
Plug-in jumper not inserted
Indirect reset
–
Plug-in jumper R removed
–
Outputs 3, 4, 11, 12, and 14 are enabled immediately after the reset button is pressed: the alarm message
disappears immediately.
Direct reset
–
Plug-in jumper R inserted
–
Outputs 3, 4, 11, 12, and 14 are not released after the reset button is pressed until the moisture has been
removed from the sensor: the alarm message does not disappear until the damage is remedied.
=== Ende der Liste für Textmarke Content ===
Operating Instructions | 1473-1-8179
Alarm behaviour
With storage of the alarm status
Without storage of the alarm status
Reset mode
Indirect reset
Direct reset
Installation and electrical
connection
— 10 —
Advertisement
Table of Contents
