Page 1
Connect the card to the control panel on the indicated terminals. The control panel must be without power supply. When the control panel is power supplied, the V-LCD is on standby mode and the following message will appear on the screen of the V- LCD.
Programming mode It allows programming the maneuver of the door. There are two possible ways of programming the maneuver (with absolute encoder or without it). Example 1: Programming sequence with absolute encoder BEING ON STANDBY MODE PRESS PROG BUTTON PRESS START BUTTON PRESS PLUS + MINUS 2s PRESS ↑...
Page 3
Param config mode It allows editing all the parameters of the control panel and changing them. Example 1: EDIT INPUTS BEING ON STANDBY MODE PRESS PROG BUTTON PRESS PROG BUTTON PRESS PROG BUTTON PRESS PLUS + MINUS 2s TO PRESS MINUS BUTTON TO PRESS PROG BUTTON TO WAIT ENTER MENU...
PRESS PLUS + MINUS 2s TO PRESS MINUS BUTTON TO PRESS PROG BUTTON TO WAIT ENTER MENU GO DOWN THE MENU SELECT THE “>” OPTION PRESS PROG BUTTON PRESS PLUS BUTTON TO PRESS MINUS BUTTON TO PRESS PROG BUTTON TO SELECT A DIGIT POSITION CHANGE THE NUMBER VALIDATE...
Page 5
WAIT TO SEE THE FUNCTION THAT HAS THIS OUTPUT Language config mode It allows changing the language of the V-LCD. There are three available languages in each control panel, different languages depending on the customization. Example BEING ON STANDBY MODE...
This equipment is designed to be installed with Versus control panels. It is not guaranteed for directly activating equipment other than that specified. The manufacturer reserves the right to change the specification of the equipment without prior warning. JCM TECHNOLOGIES, S.A. declares herewith that the product V-LCD complies with the requirements of the 2006/42/CE Machinery Directive, as well as with the ones of the 2004/108/CE Electromagnetic Compatibility Directive and 2006/95/CE Low Voltage Directive, insofar as the product is used correctly.