Advertisement
MAINTENANCE
If the lamp inside the Insect Killer requires replacing, follow the steps below.
CAUTION: Ensure the appliance is disconnected from the mains prior to
changing the lamp.
1.
Remove the collection tray by
squeezing the two recesses on the
tray firmly and pulling the tray away.
Note: Remove the tray over a rubbish
bag to avoid dropping any insects.
3.
Pull the connector away from the pin
and gently move to one side.
5. When fitting a new lamp ensure it is securely fitted with the two pins facing
towards you at the base of the appliance and with the pins set parallel to
the lines on the base of the Insect Killer (see Fig. 3).
6. Once the lamp is in place reverse the above instructions to re-fit the
connector and collection tray.
7. To re-fit the lamp cover simply place it back over the connector and pins,
before clipping it back into place.
Note: The connector can be fitted onto any of the two pins.
2.
Release the clips of the lamp
cover using a screwdriver. Pull the
screwdriver in the direction indicated
above.
4.
To remove the lamp, hold the end
of the lamp and pull it up towards
yourself.
Advertisement
