Installation; Preparing For Use - microHAM DIGI KEYER Manual

Installing DIGI KEYER consists of several steps:
1) preparing DIGI KEYER to work with your radio
2) installing microHAM USB Device Router (the control and interface software)
3) installing the USB drivers
4) configuring the Windows USB Audio Device
5) configuring Router
1. Remove the top cover from the DIGI KEYER and set the CAT jumpers as shown in the following chart.
The CAT interface jumpers must be configured to select the proper level for each radio type.
RS-232 levels: Elecraft K2, JRC JST-245, Kenwood
TS-480, 570, 870, 2000, Ten-Tec Argonaut, Jupiter,
Omni V, Orion, Pegasus, Yaesu FT-847, 920, 1000MP,
Mark V, Mark V Field, 2000, 9000
IF-232 levels: Kenwood TS-140, 440, 450, 680, 690,
711, 790, 811, 850, 940, 950
FIF-232 levels: Yaesu FT-100, 736, 747, 757GXII, 767,
817, 840, 857, 890, 897, 900, 980, 990, 1000, 1000D
CI-V levels: All Icom radios, Ten-Tec Omni VI
2. Plug the DB15M on the radio cable set into the DB15 connector on the rear panel of the DIGI KEYER
and plug ALL connectors from the cable set to the appropriate jacks at the rear panel of your
transceiver. Each connector on the radio interface cable is marked same as the matching jack on your
transceiver. DO NOT turn on the radio or external power supply at this time.
3. If the radio cable ends with leads for external power, connect these leads to a 12-16V DC power supply.
Be sure to observe the proper polarity.
microHAM © 2006 All rights reserved

4 - INSTALLATION

Preparing DIGI KEYER for Use
Note: the CAT interface is not configured at the factory.
4
RS232
IF232
FIF232
CI-V