Advertisement
GB
I. INTRODUCTOR INFORMATION...
There is a power cord and additional fuse and guarantee form in the plastic bag attached to the
unit by the manufacturer.
On the rear panel there are following switches and terminals:
- AC main cord connector AC INPUT 220V/50Hz (with FUSE socket)
- Power amplifier switch AMP ON / OFF
CAUTION:
In the Mini Voice is T 630 fuse applied. Other value of the fuse may cause
damage of the unit. The burn out of the fuse does not have to stand for amplifier's damage.
II. TURNING ON THE MINI VOICE
1. Connect the power cord in to 220V / 50Hz power supply
2. Turn on the power switch
3. After the switch the yellow control indicator on the rear panel shall light
4. The battery starts automatically charging after connection to the power supply
III. TECHNICAL DATA 'S
PSS-50
- Speaker
8" (98dB)
- Output power
40 Watt
-
Frequency response
60...16000 Hz
-
Wireless mic. range
40 m
-
Sensitivity:
1-Mic/line input
- 45 dBu/-15 dBu
2-Stereo Tape/CD/MD
- 15 dBu
3-Stereo MiniJack input
- 15 dBu
- 2-Band-EQ (each channel)
+/- 15dB
-
Dimensions
(WxHxD)
230x355x220 mm
-
Weight
8,5 kg
PSS-100
- Speakers
2 x 8" (98dB)
- Output power
80 Watt
-
Frequency response
55...16000 Hz
-
Wireless mic. range
40 m
-
Sensitivity:
1-Mic/line input
- 45 dBu/-15 dBu
2-Stereo Tape/CD/MD
- 15 dBu
3-Stereo MiniJack input
- 15 dBu
- 2-Band-EQ (each channel)
+/- 15dB
-
Dimensions
(WxHxD)
230x525x220 mm
-
Weight
10 kg
IV. THE WIRELESS MICROPHONE SYSTEM
1. Turn on the Mini Voice according to no. II.
2. Switch on the microphone with a small switcher on the microphone body. During 1 sec the red
indicator on the microphone shall light.
3. After the microphone is ready on the rear panel of the Mini Voice the red indicator of
WIRELESS ON (LED`s panel) shall light.
4. With the VOL potentiometer in 3-channel control the volume of Mini Voice.
CAUTION:
The hand hold microphone can be used only with 6F22 9V battery. Check the
battery before every use.
V. BATTERY
There is a 12V / 7,5Ah rechargeable battery with automatic charger installed inside of the unit.
This allowed use for 8 hours (PSS-100 - 5 hours) with maximum power consumption. For usual
verbal use the time of using would be much longer.
Conservation and charging.
The automatic charger installed inside the unit is taking care for the condition of the battery by
recharging and using. There is three information indicators on the rear panel of the Mini Voice:
OK
- Informs a battery is in full.
LOW
- The battery needs to be recharged. Plug the main cord in to the power supply.
CHA
RGE
- Informs about present recharging.
Working the system with connection to the AC does recharging of the battery. When the battery
is over the recommended time of recharging is 5 to 10 hrs. Automatic charger protects also
against overdosing and damaging of the battery. The recharging process is shorter in case the
power amp is turned off.
VII. LINK
To raise the power and the number of accessible input and microphones each Mini Voice can
be linked to other unit. Restricted is use of the unit with the same frequency of the wireless
system.
XLR-mic, Jack-line socket
max
Mikrofonkabel, Musikinstrument
Wejœcie mikrofonowe, liniowe
Link IN...OUTPUT terminals
Ein/Ausgang für Anschluß weiterer
Wejœcie/wyjœcie komunikacyjne
Tape, CD, MD stereo input
max
MiniJack: Walkman, PC...
AC main cord connector
IN
A
PSS 50(100) Systeme
IN
Tonbandgerät, CD, MD
IN
Battery status LED`s
B
Batterie kontrollampe
LED-y stanu Akumulatora
Netzbuchse
S
Gniazdo zasilania
Fuse socket
N
Sicherungsockel
Gniazdo bezpiecznika
Volume control
V
Lautstärkregler
G³oœnoœæ
Bass control
B
Tieftonregler
Niskie tony
Treble control
T
Hochtonregler
Wysokie tony
Wireless MIC volume control
Lautstärke des schnurlosen Mikros
M
G³oœnoœæ mikrofonu bezprzewodowego
Power amp ON...OFF
EIN...AUS-Schalter
S
Wy³¹cznik wzmacniacza mocy
Wireless MIC LED
Kontrollampe Mikrofonsender
W
LED mikrofonu bezprzewodowego
Amp ON LED indicator
Kontrollampe Verstärker EIN
A
Kontrolka w³¹czenia wzmacniacza
VHF mic
Advertisement
