Oasis YC4000 Owner's Manual

YC4000 Air Compressor
Owner's Manual
Warning!!!
Warranty is void if unit is disassembled or operated
without proper lubrication!
SAFETY INFORMATION
WARNING!!!
You are completely responsible for your own safety and the safety of those with you.
Oasis Mfg. will not be responsible and will not assume any liability for indirect,
incidental, or consequential loss, damage, injury, expense or inconvenience to property
or persons as a result of use or misuse of this product.
Compressor and motor surfaces become extremely hot during use!
burns, do not touch any part of this equipment, with bare hands
minutes immediately following operation
1. Only persons who have read and understand these instructions should be
allowed to use this compressor.
2. The air produced by this compressor is not fit for human or animal
consumption and it must not be used to provide a breathing air supply.
3. Do not operate compressor with any damaged hose(s) or after the compressor
or attachments have been dropped or damaged.
4. Never use while sleepy or drowsy.
5. Do not use near flames.
6. Do not pump anything but air.
7. Never point any air nozzle at any person or animal. Serious injury may result.
8. Under no circumstances ever rely on a safety valve alone to protect this
compressor in place of a pressure switch.
9. Never operate near a flammable gas or liquid. Never store flammable liquids
or gasses in the vicinity of the compressor.
10. Keep this equipment's exterior clean and free of oil, solvent and grease to
reduce fire hazard.
11. Release all pressure from the system before attempting to install or perform
maintenance to the system (tank, air lines, etc.).
12. Be sure any tools or attachments are compatible with the pressure and flow rate
of this equipment.
13. Check all fasteners at frequent intervals for proper tightness and cleanliness.
14. Do not attempt to disassemble, modify or repair this equipment.
INSTALLATION
Mounting location should be:
Vertical – The intake and output fittings must be located on top of the compressor for
proper lubrication.
Dry – Avoid mounting in a location that may become submerged if possible.
intake filter must be mounted in a dry location.
remotely mount it if necessary.
Cool and well ventilated – This will allow the compressor to run for longer periods.
Away from combustible/meltable materials – Compressor gets extremely hot during
operation.
To avoid serious
during or for up to 30
The air
Use a section of 5/8" heater hose to