CCL ELECTRONICS C3107B User Manual

LONG RANGE WIRELESS FLOATING POOL & SPA SENSOR
Model: C3107B
Thank you for selecting this delicate pool & SPA sensor. Utmost care has gone into the
design and manufacture of the sensor. Please read the instructions carefully according to
the version you purchased and keep the manual well for future reference.
OVERVIEW
WIRELESS THERMO POOL SENSOR
1
8
1. LCD display
2. Thermo sensor
3. [ °C /°F ] key
4. [ CHANNEL ] slide switch
- Assign the sensor to channel 1,2,3,4,5,6 or 7.
5. Battery compartment
- Accommodates 2 x AA size batteries.
6. [ RESET ] key
7. Wire hole
8. Top case lock indicator
GETTING STARTED
1. Turn the bottom case anti-clockwise
to open.
User Manual
3
6
2
7
2. Select the sensor channel.
3. Remove the battery door.
4. Insert 2 x AA size batteries into the
battery compartment. Make sure you
insert them the right way according to
the polarity information marked on the
4
battery compartment.
5. Close the battery door.
5
6. Twist the bottom case clockwise and
make sure the top and button lock
indicator align to complete the setup.
NOTE:
Ensure the water tight O-ring is properly
aligned in place to ensure water resistant.
NOTE:
- Do not twist the sensor cable and keep it straight.
- Once the channel is assigned to a Wireless thermo sensor, you can only change it by
removing the batteries or resetting the unit.
- After replacing the batteries of the wireless sensor or the unit fails to receive wireless
sensor signal of a specified channel, press [ SENSOR ] key on the console unit to
manually receive the sensor signal again.
LCD DISPLAY ON THE SENSOR
Once the sensor power up, you can find the following information that show on the
sensor's LCD display.
1
2
1. Current channel of the sensor (e.g. switch to channel "6")
2. Low battery indicator
3. Current Temperature reading
WIRELESS SENSOR SIGNAL RECEIVING (DISPLAY CONSOLE)
This pool sensor can support different 7CH console, user can base on the following step
to setup the display console.
1. In normal mode, press the console [ SENSOR ] key once to start receiving the
sensor signal of current on displaying channel. The signal icon will flash.
For example, when CH 6 is displayed, pressing [ SENSOR ] key will start receive for
CH 6 only.
2. The signal icon will flash until the reception succeeded. If no signal is received within
5 minutes the icon will disappear.
AA x 2
3