Expansion Module Slot; Default Settings - 3Com SuperStack 3 4900 SX Getting Started Manual
3com superstack 3 4900 sx: quick start
Hide thumbs
Also See for SuperStack 3 4900 SX:
- Datasheet (2 pages) ,
- Datasheet (6 pages) ,
- Getting started manual (82 pages)
Table of Contents
Advertisement
16
C
1: I
HAPTER
NTRODUCING THE
Expansion Module
Slot
Default Settings
S
4900 SX
WITCH
You can use this slot to install an Expansion Module. Contact your supplier
for further information.
WARNING: When an Expansion Module is not installed, ensure the
blanking plate is fitted by tightening all screws with a suitable tool.
Table 6
shows the default settings for the Switch 4900 SX. If you initialize
the Switch units, it is returned to these defaults.
Table 6 Default Settings
Feature
Port Status
Port Speed
Duplex Mode
Flow Control
Broadcast Storm Control Enabled
Virtual LANs (VLANs)
Multicast Filtering
Spanning Tree Protocol
Switch 4900 SX
Enabled
1000BASE-SX
Full duplex
Auto-negotiated
High threshold: 3000 broadcast frames per second -
Notify and filter
Low threshold: 1500 broadcast frames per second -
Notify and unfilter
All ports belong to the untagged Default VLAN
(VLAN 1) only. 802.1Q learning is disabled
IGMP filtering is enabled
Disabled
Advertisement
Table of Contents
Need help?
Do you have a question about the SuperStack 3 4900 SX and is the answer not in the manual?
Questions and answers