Advertisement
Quick Links
19" WOOD RACKS 4U – 16U
ASSEMBLY INSTRUCTIONS
Your Kit Consists of
2 x Top/Bottom Panels
2 x Side Panels
4 x Stick-On Feet
The mounting
Rails should be
positioned at the
front of the rack
Pilot Holes for
mounting
Rear Rails are
provided
See accessory
listings
C
Panels C & D
Position panels C & D
behind the connector
your hand only, tap
DO NOT TIGHTEN
A
Panels A & B
blocks as shown
Using the heel of
them into place
THE SCREWS
A
If fitting Plexi-Glass
Doors put this edge
at the FRONT of the
rack
Check all the
drilled edges are
on the same side
D
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Penn Elcom Rackz Limited Credenza Wood Rack Series
- Page 1 19” WOOD RACKS 4U – 16U ASSEMBLY INSTRUCTIONS Your Kit Consists of Panels A & B 2 x Top/Bottom Panels 2 x Side Panels 4 x Stick-On Feet The mounting Rails should be positioned at the front of the rack If fitting Plexi-Glass Doors put this edge Panels C &...
- Page 2 Position top panel B inside C & D in-line with the connectors Using the heel of your hand tap the sides into place DO NOT TIGHTEN ANY SCREWS Now check & align the sides they should fit 2mm inside all leading edges If they are tight just tap with the flat of your hand DO NOT USE TOOLS...
Need help?
Do you have a question about the Rackz Limited Credenza Wood Rack Series and is the answer not in the manual?
Questions and answers