Charging The Shaver - Braun InterFace 3610 Owner's Manual

1 Description
1 Foil protection cap
2 Shaving frame
2a Shaving foil
2b Floating cutter
3 Cutter block

2 Charging the shaver

• For the 3 first chargings: Plug the shaver into an electrical outlet and charge
it for at least 16 hours (switch position «off»).
The charging light (7) illuminates when the shaver is plugged in.
Then shave without the cord until it runs distinctly slower.
• Subsequent charges will take approximately 16 hours.
The full capacity is reached after several charge/discharge cycles.
A full charge will give you approximately 30 min shaving capacity.
• Wattage: 1 Watt
Voltage range during charging: 100-240 V2/ 50 or 60 Hz (automatic adaptation)
Best environmental temperature range for charging: 60 °F to 95 °F /
15 °C to 35 °C
3 Shaving
Switch positions
off = Switch is locked.
To activate it, press the red button and push the switch up:
on = Combination shave (simultaneous use of floating cutter and
shaving foil). The floating cutter cuts longer beard hairs or curly
«problem hairs», the foil follows to give a close, smooth shave (b).
foil = Shaving foil without floating cutter.
trim = The long hair trimmer is activated (for trimming sideburns, moustache
and beard) (c).
Tips for the perfect shave
• We recommend that you shave before washing, as the skin tends to be
slightly swollen after washing.
• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction of beard growth.
• Replace the shaving foil and cutter block every 1
are worn, to ensure optimum shaving performance.
6
4 Release button
5 Pop-out long hair trimmer
6 Switch
7 Charging light
8 Shaver socket
1
/ years, or when the parts
2