Nuga NM-700P User Manual page 8

How to Use the Product
ow to use ultrasound wave
Introduction
i
of uses.
DC IN
PWR
DC IN
PWR
NM-700P
1
step.
Connect the ultrasound probe
cable to the main device.
Connector of the
ultrasound probe
burns.)
DC IN (DC 24V)
adaptor connector
2
step.
OFF
Connect the adaptor and the
power cord to the service
ON
outlet. Connect them to the
main device and turn the
power switch to 'ON.'
3
step.
Press the power button to
turn on the main device.
(Power button color: red (lit)
4
step.
1) Press the 'Ultrasound
Start / Stop' button to switch
to the ultrasound mode.
2) Press the ultrasound
2
use.
1
Note
i
The output level is established to
on the main body of the product.
5
step.
When you are finished, press
the 'Ultrasound Start / Stop'
ultrasound mode.
Caution
When the ultrasound
stimulator is not in use,
press the 'Ultrasound Start
/ Stop' button to turn it off.
when not in use may
cause malfunction/failure.
Note
i
the power will turn off
automatically.
6
step.
Remove the power cord from
the connected outlet after
use.
How to Use the Product