(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by VIAVI could void the user's authority to operate the equipment.
Page 4
VIAVI has established a take-back process in compliance with the EU Waste Electrical and Electronic Equipment (WEEE) Directive, 2012/19/EU, and the EU Battery Directive, 2006/66/EC. Instructions for returning waste equipment and batteries to VIAVI can be found in the WEEE section of the VIAVI Standards and Policies web page.
California and the state’s drinking water and environment from excessive exposure to chemicals known to the state to cause cancer, birth defects or other reproductive harm. For the VIAVI position statement on the use of Proposition 65 chemicals in VIAVI products, see the Hazardous Substance Control section of the VIAVI Standards and Policies web page.
Page 6
MCA III Install Guide 22137818, Rev. 001 Jan 2020...
Before You Begin Thank you for purchasing the Seeker MCA III. This guide provides setup and operating instructions to get you up and running as soon as possible. Technical assistance If you require technical assistance, call 1-844-GO-VIAVI / 1.844.468.4284. Outside US: +1-855-275-5378 Email: Trilithic.support@viavisolutions.com...
Users can efficiently download configurations to one or more leakage detectors. The following software is required for leakage data analysis using the Seeker MCA III: Leakage Analysis Workshop (LAW) is software that manages the storage and retrieval of leakage information collected by vehicle mounted Seeker GPS systems.
A guided tour of your Seeker MCA III Front view Display Display screen The display is used to show the setup and operation status of the MCA III. Side view USB port The USB port is not used at this time.
Rear view 1. Cellular Antenna connection – Not used at this time. 2. Mobile Mount Serial Data connection – Used with the MCA III serial cable to connect the Seeker or Seeker X Mobile Mount to the MCA III. Also, power is supplied to the MCA III through this connection from the Mobile Mount.
Page 11
Seeker Mobile Mount & MCA III assembly The following steps show how to install the Seeker MCA III onto the bottom of the Seeker or Seeker X Mobile Mount. For these examples, we show assembly of the Seeker Mobile Mount, but the same process is used for the Seeker X Mobile Mount.
Page 12
Mount in the vehicle as shown in the installation guide for your unit. Also, configure these units using the Seeker Setup Software. 1. Connect the Seeker or Seeker X Mobile Mount to the Seeker MCA III using the serial data cable. Serial data cable...
Page 13
Mobile Mount & MCA Ill (optional) connection rear view GPS receiver 3. Connect the Wi-Fi antenna to the Seeker MCA III. Mount the antenna in a location that will enable communication with Wi-Fi access points. Mobile Mount & MCA Ill rear view Wi-Fi antenna...
Technical assistance If you require technical assistance, call 1-844-GO-VIAVI / 1.844.468.4284. For the latest TAC information, visit http://www.viavisolutions.com/en/services-and-support/support/technical-assistance Additional information For more detailed information, contact us at Trilithic.support@viavisolutions.com for these additional documents. Seeker MCA III User’s Guide Seeker X Installation Guide Seeker Setup Software User’s Guide...
Page 16
22137818 Rev. 001, Jan 2020 English VIAVI Solutions North America 1.844.GO VIAVI / 1.844.468.4284 Latin America +52 55 5543 6644 EMEA +49 7121 862273 APAC +1 512 201 6534 All Other Regions viavisolutions.com/contacts email Trilithic.support@viavisolutions.com...
Need help?
Do you have a question about the Seeker MCA III and is the answer not in the manual?
Questions and answers