LED indicators
Features
Standby Mode
• 22 Channels with
Preset privacy
codes
• User Adjustable
When Battery low
Privacy Codes (38
CTCSS codes)
• Hands-Free
Operation (VOX)
When you press and
hold Talk button and
• Speaker/
Microphone Jack
the Radio is
transmitting
• Roger Beep
Selectable On/Off
• Battery/Power
During VOX feature
Saver
enabled
• Keystroke Tones
• Low Battery
Power Off the Radio during charging
Audible Alert
• Auto Squelch
• Holster with Swivel
Under Charging
Clip
• IP54 Dust
Protected and
Fully Charge
Water Resistant
Maximum range may vary and is based on unobstructed
line-of-sight communication under ideal conditions.
2
Green LED flashes
every 5 seconds
Red LED flashes every
5 seconds
Green LED on
Blue LED flashes every
5 seconds
Solid Red (No ash)
Solid Green (No ash)
Caring for Your microTALK
Your microTALK
radio will give you years of trouble-free service if cared for
®
properly. Handle the radio gently. Keep the radio away from dust. Never put
the radio in water or in a damp place. Avoid exposure to extreme
temperatures.
Installing Batteries (Battery already pre-installed)
To install or replace batteries:
Remove Holster
1. Remove Holster by releasing the belt clip latch and
slide the holster downward.
2. Unscrew 2 screws at battery door with a proper
screwdriver, you may use a Philips* Head #1
screwdriver to open it.
Remove Screws
3. Open the battery compartment cover, connect the
connector of the battery to the socket of the radio
inside the battery compartment in proper polarity.
4. Place the battery inside battery compartment and
align the wires as shown.
(Note: Wires are required to be tucked into the battery
Battery Connector
compartment completely and carefully. If any object
interfere the O-ring, its sealing performance will be
1
affected.)
2
5. Place the battery compartment cover, screw down the
screws mildly.
Wires Alignment
(Screw nuts may be damaged if overtighten)
6. Re-attach the holster.
Radio
®
3
Need help?
Do you have a question about the microTALK PX280 and is the answer not in the manual?
Questions and answers