Subscribe to Our Youtube Channel
Summary of Contents for EMB Downdraft
- Page 1 Assembly and operating instructions for EMB DOWNDRAFT EXTRACTOR HOOD as of 08.2016...
- Page 2 Notes Page 6 Initialisation run Page 6 Maintenance Page 6 No function Page 7 EMB Edelstahl Möbel Beck, Brückenstraße 11, 74219 Möckmühl-Züttlingen, Germany, Tel: + 49 (0) 62 98 - 9 12 01 - 0, Fax - 17, info@emb-edelstahlmoebel.de, 01.2017...
- Page 3 Warranty claims cannot be asserted for any Important notes damage which results Safety information from failure to observe these instructions. Damaged devices must not be used. We reserve the right to make technical changes. The device must only be connected by a specialist in compliance with the pertinent Before using for the first time rules and the state building regulations.
- Page 4 It is recommended to allow the fan to continue operating for a few minutes after cooking. This helps to remove any remaining steam and odours from the air. The run-on function provides the option of having the fan switch off automatically after 15 minutes. The extractor fan features a filter cleaning display which reminds you to clean the filters after 30 hours of service.
- Page 5 With extraction mode stainless steel surfaces with a care product, The exhaust air can be guided in all directions, e.g., EMB Etolit stainless steel finish. Always the relevant connection parts must be stated work in the surface’s grinding direction and do...
- Page 6 Assembly of foot extensions (only for extraction model) Kitchen work surfaces which are thinner than 34 As of a kitchen work surface height in excess of mm can be prevented from sagging by using thread screws M4x25 which are screwed into 850 mm, the foot extensions supplied must be the upper frame.
- Page 7 If the downdraft ventilation is aligned in the cut-out in the kitchen work surface and if the loose cover is exactly flush with the work surface in the lower position, you can also adhere the cover to the mounting plate.
- Page 8 Maintenance Magnet Firstly disconnect the device from the power supply before performing any repairs or maintenance work. Lifting cylinder attachment We hope you enjoy using your new extractor fan. Note If work on the building site is not yet complete, there is a risk that the device could be operated by third parties.
Need help?
Do you have a question about the Downdraft and is the answer not in the manual?
Questions and answers