Iveco IVECONNECT Manual

I - P
VECONNECT
IVECONNECT UPDATE PROCEDURE
Before updating the Iveconnect system, please ensure the vehicle is safely parked and in
key-off condition. During the update procedures, any battery disconnection or any USB
pendrive unexpected removal may compromise the operating condition of the system.
Iveconnect system can be updated following a 2 steps procedures:
• Iveconnect System Update
• Iveconnect Applications Update
Note: the entire Iveconnect Update procedure will take approaximately 20 min and System
Update (......Pack1.zip ) should be started first!!
Iveconnect System Update
The USB Pendrive used for the update has to be empty and formatted .
Download from the web page where this file has been downloaded, the files listed below:
• XXXX_pack1.zip
• XXXX_pack2.zip
The notation XXXX is used intentionally; these are numbers that identify the last software version available
for download on the web page (i.e. for the Iveconnect System Update it could be 2412_pack1.zip) .
Uncompress the 3 files contained in the
Pen Drive, these 3 files are named as follows:
1) ULDRMode_Popup.CAB
2) install.lst
3) flash.bin .
Please ensure all the above files are present in the USB Pendrive and follow the steps outlined below to
start and complete the Iveconnect System Update:
A. Switch ON the Iveconnect system by pushing the power-on button
screen and wait until the home page appears (see Figure 1 - Home Page below)
B. Plug the USB PenDrive containing the 3 files listed above into the Iveconnect USB connector located
on the upper shell of the vehicle ( see Figure 2).
Software Update
ROCEDURE FOR
contains files for Iveconnect System Update
contains files for Iveconnect Applications Update.
XXXX_pack1.zip
Figure 1- Home page
VIA
and copy them in the root folder of the USB
1/4
USB
PENDRIVE
, confirm the Disclaimer